Table of Contents
Advertisement
Preferably use a new blade. Sharpening reduces the blade's weight and puts the
Note:
cutting disc out of balance. Large imbalance will cause vibrations of the whole crusher and
excessive stressing of the electromotor bearings.
Important! When machine-sharpening the blade, you must simultaneously cool it with water,
otherwise the blade edge will loose its hardness and cutting ability!
Before fitting the blade to the cutting disc, carefully clean all contact surfaces, both on the blade and the disc.
Always use new nuts. The nuts are self-locking, and when loosened, lose their effectiveness.
10
Troubleshooting
(see the table below)
When trying to find out the cause of trouble or defect, you should realise that not all problems must be
caused by a defect in the machine itself. Some problems can be caused by defects in power supply.
IMPORTANT! All repairs of the electrical equipment must be carried out by a qualified
electrical technician as specified by CBWS and CMI Public Notice No. 50/1978, who fully
familiarised himself with the equipment!
IMPORTANT! All repairs and troubleshooting operations must be carried out with the
machine power drive turned off and the switched off state secured by pulling the power
cord plug out of the power supply socket.
11
Spare parts
A list of available spare parts with corresponding illustrations and order numbers is presented on page 15
and 16. Among other information, the purchase order must state:
-
Machine type and serial number
-
Part number and catalogue number as shown on page 15 and 16
-
Number of pieces
PROBLEM
1. the crusher's
The crusher is not connected to power supply
electromotor
Power failure
cannot be
Circuit breaker of the socket circuit to which the crusher is
switched on
connected has tripped
The screw holding the top part to the bottom part (on top on
the right when looking from the front) got loose and tripped the
safety switch.
2. the crusher's
The cutting disc has been blocked by a foreign body
electromotor when
switched on does
not spin (it
"grumbles")
3. material is not
The blade is blunt
crushed properly
4. when running
The cutting disc is due to repeated sharpening of the blade out
without load, the
of balance
crusher vibrates
CAUSE
12
HOW TO FIX IT
Insert the power cord plug into a
power supply socket
Call an electrician
Put the circuit breaker back into the
ON position or replace the burnt
fuse
Tighten the safety switch
controlling screw
Remove the top part as instructed
in Clause 9.2 of this User's Guide
and remove the foreign object
Sharpen or replace the cutting disc
blade as described in Clause 9.3 of
this User's Guide
Replace the blade with a new one
Advertisement
Table of Contents
