JVC CL-S200 Operation Manuals page 15

Disconnect the power cord if abnormalities such as smoke and fire, etc. are
observed. Do not position the monitor so that it is difficult to operate the
disconnection.
Even if it is used properly, the monitor may cause harmful interference to
radio or television reception. Try the following measures to correct it.
• Increase the distance between the monitor and the radio/TV.
• Connect the monitor into a different outlet from the one to which the radio/
TV is connected.
Do not press, scratch, or put objects on the LCD panel surface. It could
cause monitor noise and/or cause the panel to fail.
Do not monitor a static image for too long. It could cause "ghosting," a
phenomenon where the previous image displayed on the screen is seen for
moments after the image has changed.
Turn on a screensaver or enable the standby mode to avoid "burning in," the
burning of an image onto the LCD panel after hours of the same image
being displayed.
Please be advised that the following symptoms may occur due to the nature
of LCDs. They are not failures.
• During use in cold environments, "streaking" may occur or images may
appear dark.
• Depending on use conditions such as temperature, spots or unevenness in
luminance or color may be observed.
• Due to the manufacturing technology used, there may be pixel or dot
failures even though its rate of effective pixels is 99.999301 %.
Do not set maximum luminance or closer to it when using the monitor in a
dim room below 100 lx. It could cause eyestrain. We recommend the factory
default. Setting it too low could makes it hard to see the image.
Do not push or give a shock to the LCD luminance sensor.
set luminance level to change and/or the LCD to fail.
Clean inside of the monitor once a year. The dust could cause fire.
Ask your dealer for maintenance.
LCD
LCD luminance sensor
- 15 -
It could cause the