JVC CL-S200 Operation Manuals page 8

Guidance and manufacturer's declaration – electromagnetic immunity
The model CL-S200 is intended for use in the electromagnetic environment specified below.
The customer or the user of the model CL-S200 should assure that it is used in such an
environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and
voltage variations on
power supply input
lines
IEC 61000-4-11
Power
frequency (50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE U
is the a.c. mains voltage prior to application of the test level.
T
IEC 60601 test level
±8 kV contact
±15 kV air
±2 kV for power
supply lines
±1 kV for input/output
lines at 100 kHz rate
±1 kV line(s) to line(s)
±2 kV line(s) to earth
0 % U
; 0,5 cycle
T
At 0, 45, 90, 135, 180,
°
225, 270, 315
0 % U
; 1 cycle and 70
T
% U
: 25/30 cycles
T
°
At 0
0 % U ; 250/300 cycles
T
30 A/m
- 8 -
Compliance level
±8 kV contact
±15 kV air
±2 kV for power
supply lines
±1 kV for input/output
lines at 100 kHz rate
±1 kV line(s) to line(s)
±2 kV line(s) to earth
0 % U
; 0,5 cycle
T
At 0, 45, 90, 135, 180,
°
225, 270, 315
0 % U
; 1 cycle and 70
T
% U
: 25/30 cycles
T
°
At 0
0 % U ; 250/300 cycles
T
30 A/m
Electromagnetic
environment
–guidance
Floors should be wood,
concrete or ceramic
tile. If floors are
covered with synthetic
material, the relative
humidity should be at
least 30 %.
Mains power quality
should be that of a
typical commercial or
hospital environment.
Mains power quality
should be that of a
typical commercial or
hospital environment.
Mains power quality
should be that of a
typical commercial or
hospital environment. If
the user of the model
CL-S200 requires
continued operation
during power mains
interruptions, it is
recommended that the
model CL-S200 be
powered from an
uninterruptible power
supply or a battery.
Power frequency
magnetic fields should
be at levels
characteristic of a
typical location in a
typical commercial or
hospital environment.