Garrison 046-2668-2 Operating Instructions

Keyless Entry Deadbolt Lock with Remote Controls
Operating Instructions
"C" button used
to clear entries
◆ To unlock the lock
Using Keypad: Enter a valid user code and press
Using Remote: Press remote
◆ To lock the lock
Using Keypad: Press
Using Remote: Press remote
◆ Add a new user code
◆ Delete one existing or preset user code
◆ Delete all user codes
◆ Create a temporary code
◆ Change current or preset programming code
◆ Add a new remote controller
◆ Delete all remote controllers
◆ Set or cancel auto lock
Set auto lock:
Cancel auto lock:
◆ Programming code reset
Disconnect the battery. Reconnect the battery and wait for long beeps and short beeps. Press
programming code will be reset to preset.
Low battery warning: beeps and LED flashes red for 5 seconds. Please replace with good quality alkaline batteries
Valid programming: 1 long beep and LED flashes green.
Invalid programming: 2 long beeps and LED flashes red.
Lock error: 3 long beeps and LED flashes red.
Warning sounds and LED flashes red after 4 incorrect code attempts; keypad shuts down for 30 seconds
Imported by Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8
Padlock button used to
activate lock and
during programming
and then hear 1 beep and lights green.
button. You will hear 1 beep and see a green light.
and then hear 2 beeps and lights red.
button. You will hear 2 beeps and see a red light.
(You can add up to 10 new user codes)
New Re-enter New
Existing Re-enter Existing
Re-enter
Re-enter New
Re-enter Existing
Re-enter New
(You can add up to 10 new remote controllers)
beeps and lights green. To add new remote, press remote
Re-enter
046-2667-4
046-2668-2
•
IMPORTANT: The lock comes factory preset with
a programming code (123456)
and a user code (123).
Please change the programming
code and user code as soon as
possible after installation to
ensure security.
See below for instructions.
* Note: 1. Code numbers can be any combination of
2-8 digits.
2. When pressing the remote control
button or button it must be directed
towards the outside of sensor plate.
button.
3 times in 3 seconds, and the lock