Page 2
NookBox Installation Guide Glass/Break Detector NookBox Glass/Break Detector (P119001/E6309661) The Glass Break Detector detects the high frequency sound emitted by glass breakage and transmits signal to notify the alarm system control panel when it is triggered.
NookBox Installation Guide Glass/Break Detector Parts identification 1. Green LED Indicator (Inside) 2. Red Indicator (Inside) 3. Microphone 4. Dip Switch 5. Battery Compartment 6. Learn/Test Button Press the button once to send a learn code. 7. Tamper Switch The tamper switch is compressed against the back cover and protects the Detector from cover opening or removal from mounted location.
NookBox Installation Guide Glass/Break Detector LED Indicator • The LED indicators are inside the front cover and only visible when activated. • Red LED: The Red LED activates when: » Tamper Switch is activated. » Learn/Test button is pressed. » Glass break detected under Test Mode, Low Battery or Tamper open condition (The Red LED does not light up when glass break is detected during normal operation) •...
NookBox Installation Guide Glass/Break Detector Test Mode The Test mode is used to help check the Glass Break Detector’s detection distance. When the Learn/Test button is pressed, the Glass Break Detector will enter Test mode for 5 minutes. Pressing the button again during the 5-minute period will reset test mode time to 5 minutes.
NookBox Installation Guide Glass/Break Detector Installation The Glass Break Detector should be mounted on ceiling or wall. There should be no obstacle between the Detector and the window protected. The Detector back cover has mounting knockouts which can be broken for screw mounting. Alternatively, you may also mount the detector with double side adhesive tape provided.
Page 7
NookBox Installation Guide Glass/Break Detector For more information visit: www.getnookbox.com...