Table of Contents
Advertisement
Modes
MAC 1 has 3 different modes:
1) PLAY-mode
2) EDIT-mode
3) MIDI-mode
PLAY-mode is the start up mode.
EDIT-mode and MIDI-mode are described in the following.
Editing and programming
Loopsection
Press once on the EDIT/STORE button (F7).The button lights up, as you enter edit mode. Each loop can
now be activated individually by pressing one of the 8 buttons within the loop section.The LED indicators
above each loop acts as an on/off status indicator.
Note: The unit will not be muted if a loop is activated without anything connected to it.
Switch:
In edit mode switch A/B is activated/deactivated by pressing the A/B buttons (F11-F12).
FX MIX section:
Press once on the EDIT/STORE button (F7).The button lights up as you enter EDIT mode. Press once on
the mixer you want to edit - FX mix A (F9) or FX mix B (F10).
The button lights up indicating that the chosen mixer is ready for editing.
Use the VALUE WHEEL (F5) to vary the mix of the stereo effects loop between "000" and"127".
At "000" only the direct signal is heard while "127" is maximum effected signal.
Press the FX mix button when you have finished the editing of FX mix and return to general EDIT-mode.
Storing your presets:
When you are satisfied with the editing that you have done, storage is achieved in the following way.
Push the EDIT/STORE (F7) once, the LED will go out, and the new preset is stored at the present
patch location.
Note: When programmed for external control via expression pedal, the mixers FX A or FX B cannot be
edited as usual as they are now in "slave-mode"
To Re-initialise MAC 1
This procedure will reset the unit
Warning: Your edited patches will be lost if the unit is re-initialised.
Procedure:
Hold down PR/CH and SWITCH B while switching on the power.
Release PR/CH first, and then SWITCH B.
6
Advertisement
Table of Contents
