IMPORTANT SAFETY
use attachments not recommended by
For a dual voltage hair dryer:
the manufacturer.
17. Be sure dual voltage selector is in correct
INSTRUCTIONS
4. Never operate this appliance if it
voltage position before operating. Before
has a damaged cord or plug, if it is
plugging in, read the information about
When using electrical appliances, especially
not working properly, if it has been
dual voltage contained in this instruction
when children are present, basic safety
dropped, damaged, or dropped into
section of this manual.
precautions should always be taken, including
water. Return the appliance to place of
18. This appliance was set at the factory to
the following:
purchase for examination and repair.
operate at 125 volts. Refer to Additional
READ ALL INSTRUCTIONS
5. Keep the cord away from heated surfaces.
Information section of this manual for
BEFORE USING.
Do not pull, twist, or wrap line cord
conversion to 250 volts operation.
KEEP AWAY FROM WATER.
around dryer.
SAVE THESE
6. Never block the air openings of the
DANGER —
Any appliance is
INSTRUCTIONS
appliance or place it on a soft surface,
electrically live even when the switch is
such as a bed or couch, where the air
off. To reduce the risk of death or injury by
openings may be blocked. Keep the air
OPERATING
electric shock:
openings free of lint, hair, and other
1. Always unplug appliance immediately
debris.
INSTRUCTIONS
after using.
7. Never use while sleeping.
2. Do not use while bathing or in the
8. Never drop or insert objects into an
This appliance is intended for professional
shower.
opening.
use. Use on Alternating Current (60 hertz)
3. Do not place or store appliance where it
9. Do not use outdoors or operate where
only. Standard dryers are designed to operate
can fall or be pulled into a tub or sink.
aerosol (spray) products are being used
at 110-125 or 220-250 volts A.C.
4. Do not place in, or drop into, water or
or where oxygen is being administered.
other liquid.
This appliance has a polarized plug (one blade
10. Do not use an extension cord to operate
5. If an appliance falls into water, unplug
is wider than the other). As a safety feature,
dryer.
it immediately. Do not reach into the
this plug will fit into a polarized outlet only
11. Do not direct hot air toward eyes or other
water.
heat-sensitive areas.
one way. If the plug does not fit fully into the
WARNING —
12. Air outlet grille and attachments may
outlet, reverse the plug. If it still does not fit,
To reduce the risk
be very hot during use. Allow them to
contact a qualified electrician. Do not attempt
of burns, electrocution, fire, or injury to
cool before handling.
to defeat this safety feature.
persons:
13. Do not place appliance on any surface
1. This appliance should never be left
while operating.
CHECK ALCI SAFETY FEATURE EVERY TIME
unattended when plugged in.
14. While using the appliance, keep your hair
YOU USE DRYER.
2. This appliance should not be used by,
out of it. Keep your hair away from the air
This hair dryer is equipped with an Appliance
on, or near children or individuals with
inlets.
Leakage Circuit Interrupter (ALCI), a safety
certain disabilities.
feature that renders it inoperable under some
15. To prolong the life of the dryer, keep
3. Use this appliance only for its intended
abnormal conditions, such as immersion in
filters clean of hair and dust.
use as described in this manual. Do not
water.
16. Do not use with voltage converter.
To make sure the ALCI is functioning properly,
SUPER STYLING GUIDE
heat and is stable in ultra-high temperatures.
perform the following test: The purpose of this
The Nano Titanium™ technology uses micro
Your best looks begin with a good haircut
test is to allow you to make sure the exclusive
that's well maintained. Always treat hair well
particles of titanium that provide the ultimate
water sensing system (ALCI) is working.
with superior quality shampoos, conditioners,
heat performance for beautiful, healthy hair
1. Plug in hair dryer and press test button on
and finishing products.
results. Nano Titanium™ yields maximum
plug (see appropriate diagram).
far-infrared heat-penetrating the hair from within
DRYING BASICS
for gentle drying without damaging hair. Nano
2. Hair dryer will stop working. There will be
1. Shampoo and condition hair with products
Titanium™ emits negative ions in their most
an audible click and reset button will pop
of your choice. Rinse thoroughly. Towel-blot
beneficial form for faster drying, locking in hair's
out.
hair to remove excess moisture. Section
own natural moisture. This Nano Titanium™
3. To reset ALCI with a reset button: Unit
hair. Using the dryer along with your styling
dryer will give your hair a smooth, silky shine
should be unplugged. Then push reset
brush, direct hot air through one section of
while eliminating frizz.
button in, and reinsert plug into outlet.
hair at a time. Move dryer steadily across
WARNING
each section so that the hot air passes
RESET
RESET
THIS APPLIANCE IS DESIGNED
through hair. Direct airflow at hair, not
EXCLUSIVELY FOR USE BY LICENSED
scalp.
COSMETOLOGISTS.
2. Keep dryer's air intake vents unobstructed
TEST
TEST
and free from hair while drying.
3. To avoid overdrying and possible damage
GET TO KNOW YOUR HAIRDRYER
to hair or skin, do not concentrate heat on
4. If ALCI is not functioning properly, return
one section for any length of time. Keep
Model BABNT053T
hair dryer to place of purchase.
dryer moving as you style.
5. It is important that if immersion occurs,
4. For quick touch-ups between shampoos,
this unit be brought to a service center.
dampen hair with a mist of water before
Nano Titanium™
ceramic grill
Do not try to reset.
styling with the dryer.
6. Be sure to repeat test every time you use
5. When using your dryer to create curls and
hair dryer to confirm ALCI is operational.
waves, dry hair almost completely on a
warmer temperature setting, then finish
7. Should the dryer go off and the ALCI
styling with cooler air.
reset button pop up during use, this
6. This dryer includes a concentrator
2 heat/speed
could indicate a malfunction in the dryer.
settings
attachment. Use the attachment when you
Remove plug from outlet and allow the
need drying power in a small area (such
dryer to cool. Push the reset button
as a curl or a wave), or when you want to
in and reinsert plug into outlet. Dryer
Dual voltage
relax curly hair.
should function normally. If not, return
to a BaByliss
®
PRO Service Center for
NANO TITANIUM™
examination and repair.
Concentrator
Your Nano Titanium™ dryer has many benefits.
nozzle
Nano Titanium™ is an exceptional conductor of
BODY & VOLUME
IF YOU MUST USE YOUR HAIR DRYER IN
To
create
extra
THE BATHROOM, INSTALL A GFCI* NOW!
volume, turn head
Your local electrician can help you decide
upside down while
which type is best for you – a portable unit
drying. Position the
that plugs into the electrical outlet or a
airflow toward the
permanent unit installed by your electrician.
roots for maximum
The National Electrical Code now requires
lift. When hair is dry,
GFCIs in the bathrooms, garages, and outdoor
gently toss head
outlets of all new homes.
back and brush hair
into place.
This message about...
G
STRAIGHTENING
Work
with
hair
in sections when
ROUND
creating
a
super
straight look. Using
fuse or circuit breaker won't protect you
a large round brush
F
under these circumstances. A GFCI offers you
(approximately 2" in
far greater protection.
diameter), hold hair
taut in each section
A GFCI can save your life! Compared
and
bend
ends
AULT
to that, the price is small! Don't wait...
slightly under as you
install one now!
dry.
Removable
C
rear filter
* GFCI is a sensitive device which reacts
with stand
immediately to a small electric current leak
by stopping the flow of electricity.
MAKING WAVES
IRCUIT
Tousled,
natural-
ADDITIONAL INFORMATION
looking waves are
easily created by
I
Folding handle
FOR DUAL-VOLTAGE DRYERS
grasping hair at the
For use in the North America, the voltage
roots and scrunching
Ultra-
selector switch should be placed in the 125
lightweight
between fingertips
position. For use in several countries overseas,
while drying.
NTERRUPTERS
6' power
the voltage selector may need to be placed in
cord
the 250 position. Confirm the voltage available
at each overseas location before using the
...can save a life!
appliance. For connection to a 240-volt supply,
use an attachment plug adapter of the proper
configuration for the power supply.
dryer, causing it to rupture and short circuit.
Inspect the cord frequently for damage. Stop
For 110-125 Volt Operation
use immediately if damage is visible or unit
Flick the dual voltage switch to the
stops or operates intermittently.
125 position. In this position, the dryer has
two settings. It provides two speeds and two
If the cord or dryer is damaged or does not
heats—low speed and low heat on LO and high
operate properly, return it for repair to place
speed and high heat on HI.
of purchase or an authorized BaByliss
®
PRO
service representative only. No repairs should
For 220-250 Volt Operation
be attempted by the consumer.
Flick the dual voltage switch to the 250 position.
WHY DO YOU NEED A
In this position, the dryer has two settings. It
STORAGE – IMPORTANT
GFCI?
provides two speeds and two heats — low
When not in use, your dryer should be
Electricity and water don't
speed and low heat on LO and high speed and
disconnected, allowed to cool and stored in a
mix. If your hair dryer
high heat on HI.
safe, dry location, out of reach of children. Do
falls into water while it's
USER MAINTENANCE
not wrap line cord around dryer. Allow the cord
plugged in, the electric
to hang or lie loose and straight at the point of
shock can kill you...even if
Your dryer is virtually maintenance-free. No
entry into the dryer.
the switch is off. A regular
lubrication is needed. The dryer must be kept
LIMITED ONE YEAR WARRANTY
clean for proper operating performance. When
cleaning is needed, unplug the cord, allow to
BaByliss
PRO will repair or replace (at our option)
®
cool and clean dust and lint from air intake
your unit free of charge for 12 months from the
openings with a small brush or the brush
date of purchase if the appliance is defective in
attachment of a vacuum cleaner. The outer
workmanship or materials.
surface of the dryer should be wiped clean
To obtain service under this warranty, return the
with a damp cloth only.
defective product to the service center listed
Blocked or clogged air intake vents will
below, together with your purchase receipt
cause the dryer to overheat. If overheating
and $5.00 for postage and handling. (California
occurs, an automatic safety device will shut
residents need only provide proof of purchase
the dryer or the heat off to prevent damage or
and should call 1-800-326-6247 for shipping
personal injury. If the unit or the heat cycles
instructions.) In the absence of a purchase
off, turn the dryer off, unplug the cord, and
receipt, the warranty period shall be 12 months
allow the dryer to cool for 10 to 15 minutes
from the date of manufacture.
before restarting. Make sure the air vents are
ANY IMPLIED WARRANTIES, OBLIGATIONS,
clean.
OR
LIABILITIES,
INCLUDING
BUT
NOT
CAUTION
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
NEVER allow the power supply cord to be
pulled, twisted, or severely bent. Never wrap
PARTICULAR PURPOSE, SHALL BE LIMITED
the cord tightly around the dryer. Damage will
IN DURATION TO THE 12-MONTH DURATION
occur at the high flex point of entry into the
OF THIS WRITTEN, LIMITED WARRANTY. Some
states do not allow limitations on how long an
Para su seguridad y para seguir
implied warranty lasts, so the above limitations
disfrutando de este producto
durante años, siempre lea las
may not apply to you.
instrucciones cuidadosamente
IN NO EVENT SHALL BABYLISS
PRO BE
®
antes de usarlo.
LIABLE FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESSED
OR IMPLIED, WHATSOEVER. Some states do
not allow the exclusion or limitation of special,
incidental, or consequential damages, so the
above limitation may not apply to you.
This warranty gives you specific legal rights, and
you may also have other rights, which vary from
state to state.
Service Center
®
BaByliss
PRO
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
Nano Titanium™
Secador de
1000 Vatios
Manual de
instrucciones/
Guía de modelado
Modelo BABNT053T
©2010 BaByliss PRO
Diseñado exclusivamente para
10BA113648
IB-9955
los cosmetólogos licenciados
Need help?
Do you have a question about the Nano Titanium BABNT053T and is the answer not in the manual?
Questions and answers
how do you get styling tips off