Installation Steps; Product Specifications - Philips Dynalite DMNG232 Installation Manual

installation steps

1. Decide if the equipment to be connected to the RS232 port
is classified as COMPUTER (DTE) or MODEM (DCE). The
factory setting for the RS232 port is Computer. To change
this setting to MODEM remove the cover and move the
mode jumpers to the MODEM position.
2. Connect the RS232 port on the DNG232 to the RS232 port
on the other device using a 9 pin D connector straight
through cable.
3. Connect the RS485 cable to the DyNet 5 way terminal strip.
Note that this device consumes 40mA of power from the
DyNet network
4. The factory settings will allow control of a Dynalite system
via plain English text strings that can be sent by a terminal
program such as the one included in Microsoft Windows,
which allows the DNG232 to be easily tested. See the
section on Plain English commands. Detailed programming
information is available in the document: DNG232
Programming Manual
connecting data cable
Connect Data Cable in a „Daisy Chain‟
recommended cable colour coding
Green/White Pair paralleled for GND
Orange/White Pair paralleled for +12V
Blue/White Pair Blue for DATA+
White for DATA-

product specifications

RS485 Serial Port:
connections
RS232 Serial Port:
RS232 Port Modes:
RS232 Data Formats:
odd/even/none
User Controls:
Internal Controls:
Operating Environment:
Power Consumption:
Compliance:
Ambient Temperature:
Construction:
Dimensions:
Weight:
Dynalite manufactured by WMGD Pty Ltd (ABN 33 097 246 921) Unit 6, 691 Gardeners Road Mascot NSW 2020 Australia Tel: +61 2 8338 9899 Fax: +61 2 8338 9333
RJ12 Socket Connections
1 x RS485 unterminated DyNet, consisting of 1 x RJ12 socket & 1 x 5 way terminal strip, for permanent
1 x RS232 9 pin female D connector
COMPUTER (DTE), MODEM (DCE)
Baud rate: 1200 - 460800, Max packet length: 254 bytes, Data bits: 7/8, Stop bits: 1/2, Parity:
Service Switch, Diagnostic LED
Programmable Logic Controller
0º to 50ºC ambient temperature, 0% to 95% RH non condensing
40mA from the DyNet network
CE, C-Tick
50C max.
ABS plastic stand alone enclosure
H 30mm x W 80mm x D 150mm
0.15Kg
DMNG232 Instruction Manual Rev E.Doc Specifications subject to change without notice
E-Mail: info@dynalite-online.com
connecting RS232 data cable
RS232 Connector: 9 pin Female D connector
RS232 Connector Pinouts
Pin Function
1 DCD (data carrier detect)
2 RD (received data)
3 TD (transmitted data)
4 DTR (data terminal ready)
5 SG (signal ground)
6 DSR (data set ready)
7 RTS (request to send)
8 CTS (clear to send)
9 RI (ring indicator)
Serial Cable Permanent Connections
recommended cable types
Belden: 9503
Garland: MCP3S
Hartland: HCK603
M&M Cable: B2003CS
Web: dynalite-online.com
Implementation
Not connected
Connected to UART
Connected to UART
Not connected
Connected to Ground
Not connected
Software controlled
Software controlled
Not connected
Dynalite: DYNET-STP-CABLE
M&M cable: B9503CS
Multicables: AWME120236209220
RS Components: 368-687