Table of Contents
Advertisement
BEFORE USE
Please read all of the instructions for use and the Important
Safeguards carefully.
Remove all packaging from the generator.
The first time the steam generator is used, it is normal for a
small amount of smoke and a slight odor to be produced.
It will quickly disappear.
When starting, and while it is being used, the electric pump
injects water into the boiler. It makes a noise but this is
normal. If you are pressing on the steam control button at
this time, you may lose a little steam for a few seconds.
HELPFUL HINTS
Before using the generator for the first time or if you have
not used the steam function for a few minutes, press the
steam button several times in a row while holding the iron
away from your clothes. This will enable any cold water to
be removed from the steam connection cord.
When ironing start with fabrics that require a low
temperature setting ( ) and finish with those which need
the highest temperature (
Mixed fiber fabrics should be ironed on the temperature
for the most delicate fabric. For example a shirt that is 60%
cotton and 40% polyester should be ironed at the ( )
setting for synthetics.
If spray starch is used, spray it onto the reverse side of the
garment. Allow starch to penetrate before ironing.
For best results, use a mesh type ironing board to allow
excess steam to escape.
For delicate fabrics, we recommend carrying out a test on
an unobtrusive area of the garment such as an inner seam.
FILLING THE WATER TANK
1. Place your steam generator on a stable, horizontal heat-
resistant surface.
(2)
2. Remove the water tank by pulling
the tabs upward (1).
(1)
3. Fill the water tank taking care not
to exceed the maximum level (2).
).
Advertisement
Table of Contents
