Diginet RAPIX eHub Installation Manual page 10

RAPIX Lighting Control System
15. Connecting masters to slaves
Slave RAPIX modular switches connect directly to masters. Slaves have an integrated flying lead with a male
connector. Masters have matching female sockets.
15.1. Typical installed connections
Typical connections between master and slave
rotary RAPIX modular switches in a two gang grid
plate
15.2. Maximum number of master / slave connections
The number of slave RAPIX modular switches supported by each type of master are shown in the table below.
Master type
Push Button
Rocker
Rotary
The maximum permissible distance between the master and slaves RAPIX modular
switches is limited to the pre-terminated slave cable length. This pre-terminated cable
must not be extended or shortened.
Connection between a
master and slave RAPIX
modular switch
Number of possible slaves connected
Slave Push Buttons or Rockers
Up to 5
Up to 5
N/A
RAPIX Lighting Control System - eHub
Typical connections between a master and three
slave RAPIX modular switches in a four gang grid
plate
Slave Rotary
N/A
N/A
1
10