Selecting The Temperature; Setting Variable Steam Control; Anti-Drip System - Rowenta Precision Steam Iron Instructions For Use Manual

SELECTING THE TEMPERATURE

Set the temperature control dial according
to the type of fabric you are ironing.
Check the fabric's label for appropriate
setting.
To avoid an automatic switch off while the iron is heating up, always
keep the iron on its heel. Start at low temperature
high temperature . For delicate fabrics we recommend carrying
out a test on an unobstrusive part of the garment (inner seam). Steam
can only be produced when the thermostat is in the red cotton/linen
zone.

SETTING VARIABLE STEAM CONTROL

Set the variable steam control to required steam volume. Steam can
only be produced when the thermostat is aligned to
(red zone). Allow iron to heat up (light goes out) before activating the
variable steam control.
Steam is produced as soon as the iron is
held horizontally.
Se lf
max C le a n
m in
Steam generation can be interrupted by
standing the iron on its heel or sliding the
variable steam control fully to the left.
ANTI-DRIP SYSTEM (depending on model)
In order to produce steam, all irons require a high temperature.
If the soleplate is not hot enough some of the water will not turn to
steam and can spit or leak from the soleplate. The new anti-drip
system automatically reduces the volume of steam when ironing at
low temperatures to prevent dripping.
6
Laundry Fabric Temperature
label
synthetics
e.g. viscose,
polyester
silk,
wool
cotton,
linen
and graduate to
Iron ready for steam ironing
Steam off
setting
or max.