Coleman QuickBed Instructions

Important Information

• Do not let inflatable products come in contact with sharp,
pointed objects.
• Fill with cold air only. Never use a hair dryer to inflate, this
could cause melting.
• Do Not Over Inflate. Bursting items can cause serious injury.
Inflate the airbed until most of the wrinkles in the material are
gone and the bed feels firm to the touch.
Caution: Air temperature and weather do affect the air
pressure in inflatable products. In cold weather your
airbed will lose some pressure do to the fact that the air
will contract. If this occurs, you may want to add a little
air to improve your airbed's performance. However, in
hot weather, the air will expand. You must let some air
out to prevent the airbed from failing due to overpressure.
You should avoid exposing your airbed to extreme
temperatures (hot or cold).
Inflation Instructions
To Inflate using Coleman
• To begin inflation, open external cap
and pull firmly on lanyard to extend out.
This will open internal yellow seal.
• When fully inflated, seal valve by pushing
in with pump nozzle. This will seal the inter-
nal yellow stopper and keep air from
escaping while closing cap.
WARNING:
Not for use by children 3 and younger or people with limited mobility. They
may suffocate in a face down position or become trapped and suffocate in the gap
between the airbed and adjacent furniture or wall. If the airbed is under inflated or
deflates during use, this risk of suffocation may increase.
Do not let young children sleep on this airbed until they are mature enough
to sleep in an adult bed. Young children can suffocate on adult beds (including
airbeds), particularly when sleeping with another person. Ask your pediatrician for
specific recommendations for your child.
Adult supervision required for inflation and deflation.
QuickBed
QuickPump Unit:
® TM
• Attach nozzle to inflation end of Pump.
Insert nozzle and turn on.
• Fully remove pump and close external
stopper. Valve should appear depressed
into itself.
Read airbed instruction manual and follow all safety instructions to avoid serious injury or death.
with Wrap 'N' Roll ™
®
Instructions
To Open / Close Valve
OPEN - STEP 1:
Internal Seal Closed
• Pull open cap.
Push to Close
Internal Seal Closed
• Reverse Steps 1 & 2. Make sure
valve seats on inner yellow post.
Deflation Instructions
To Deflate using Coleman
To Deflate without use of pump:
For video instructions go to
www.coleman.com/inflate
DO NOT OVER INFLATE
This airbed can melt or burn. Keep away from open flames,
heaters, and other hot objects. Do not smoke on or near the airbed.
This airbed is not for use in water. It is not a life saving device
personal flotation device, or water toy.
This airbed is not a toy. Do not stand, walk, jump or play on the airbed.
This can result in serious injury or damage to the airbed.
OPEN - STEP 2:
Pull to Open
Fully Opened Valve
• Firmly pull cap to unseat valve
from inner yellow post.
To Close Valve
Fully Closed Valve
• Close cap.
QuickPump
®
Remove adapter nozzle from inflation
end and attach to opposite deflation
side of pump. Repeat same steps as
inflation. This will draw the air out
quickly.
To deflate, open external stopper
and pull to extend out allowing air
to escape. When fully deflated close
stopper.
Internal
Yellow Post
Unit:
TM
NEVER USE
A HAIR
DRYER TO
INFLATE
4010005306 (20090402)