Page 1
Istruzioni per l’uso e l’installazione Cappa Instructions for use and installation Cooker Hood Mode d’emploi et installation Hotte de Cuisine Bedienungsanleitung und Installation Dunstabzugshaube Kullanım ve montaj talimatları Davlumbaz ATMOS 604 ATMOS 904 ATMOS 1204...
STEAM OFF SYSTEM STEAM OFF SYSTEM EXCLUSIVE, CONDENSATION-FREE COMFORT • In induction hobs, the thermal differential created between the hot part adjacent to the cooking top and the cooler air under the extractor side of the hood causes condensation and dripping that no one had yet managed to solve.
RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
Page 7
• If the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. Regulations concerning the discharge of air have to be fulfilled. • Use only screws and small parts in support of the hood. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
Page 8
• “CAUTION: Accessible parts may become hot when used with cooking appliances.” MAINTENANCE • Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. • Clean and/or replace the Filters after the specified time period (Fire hazard). •...
ASSEMBLY • The Hood can be directly installed in wall units deep 310mm • For deeper wall units, you can use 3 spacers supplied Wall Unit D A+B+C spacers Wall Unit 320 mm • To fit the Hood in wall units deep 320mm, use the spacer A •...
Page 11
Wall Unit 340 mm • To fit the Hood in wall units deep 340mm, use the spacers A and C • Mount the spacer A (see pag.16a); the spacer C grabs the A, then fix it as shown in the figure with screws (Ø4x6) •...
Page 12
SPACERS ASSEMBLY X, Y • Mount the spacers as shown in the figure using the screws (Ø4x6)
INSTALLATION FIXING IN WALL UNIT • ONLY mod. 560mm: it is required to remove the panels before proceeding. 1) remove the filters 3) disconnect the cables 2) remove the screws 4x (M4x10) Arrange the Hood in the wall unit, without filters •...
Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 120 mm. • Fix the pipe in position using sufficient pipe clamps (not sup- plied). •...
Control panel • Short pression: Turns the motor on at speed one, the relevant LED turns on. • Long pression: all functions turn off (excluding lights, if lit). • Short pression: Motor at the second speed, the relevant LED turns on. •...
Page 16
FILTERS MAINTENANCE Grease filters CLEANING METAL SELF- SUPPORTING GREASE FILTERS • The filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. • Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time.
Page 17
Franke S.p.a. Via Pignolini,2 37019 Peschiera del Garda (VR) www.franke.it 991.0511.835_04 - 171222 3011000061800.07 D0003789_03...
Need help?
Do you have a question about the ATMOS 604 and is the answer not in the manual?
Questions and answers