ElectrIQ CD25PRO-LE User Manual page 9

OSC. Button (oscillating function)
There are three different options, 45, 90 degree and swing, the louvers
OSC
will move in swing mode or be fixed in selected position. Use 45 degree or
swing when using the Laundry mode.
UV Light Button ( For air purification)
To select "UV", press the "UV" button and the indicator light to the right of
UV
the button will illuminate. The germicidal UV light improves the air quality by
destroying germs, bacteria, fungi.
PLASMA IONISER Button (ionization function)
To activate the ionizer press the Plasma Ioniser button. The LED to the
PLASMA
IONISER
right of the button will illuminate to show the mode is active. The ionizer can
refresh the air while killing viruses, dust mites, mould and airborne allergens.
HUMIDITY SETTING Buttons
Press UP / DOWN buttons to select the desired relative humidity level. The
default relative humidity is 55%. When a relative humidity of 35% is selected,
the compressor will not stop until the water tank is full. Please note these
buttons will not adjust the desired humidity in smart mode.
TIMER Button
When the button is pressed, the led to the left of the button will illuminate
TIMER
to show the mode has been activated. The timer can be turned off again by
pressing the timer button. The indicator LED will then turn off. The Timer can
be used in 2 different ways
Delayed power-on: With the unit in standby, activate the timer mode and
use the "UP" and "DOWN" buttons to select in how many hours time you
require the unit to start.
Delayed power-off: With the unit turned on, activate the timer mode and
use the "UP" and "DOWN" buttons to select in how many hours time you
require the unit to turn off.
INTELLIGENT DEFROST
DEFROST
The appliance will defrost automatically as programmed once the coil sensor
detects the temperature is too low, to prevent ice from building within the
unit. The defrost indicator will light up to show this mode is active. Once the
defrosting process has finished, the appliance will recover to its previous
running mode.
TANK-FULL
TANK FULL
If the water tank is full, the indicator light will flash, please empty the
water tank to continue operation. The light will also illuminate if the tank is
incorrectly fitted.
OPERATION
OPERATION
The Operation light will illuminate when the compressor within the unit
is running to extract moisture from the air. Please note this may not light
up immediately when the unit is started, and will go out when the desired
humidity is reached.
08