Selecting The Flash Array - Leica SF C1 Instruction Manual

SELECTING THE FLASH ARRAY

Sophisticated lighting scenarios, e.g. for studio portraits, often
require the use of multiple flash units. The Leica SF C1 allows you
to independently configure the Leica SF 60 and additional
system-compatible flash units. The flash units are assigned to one
of a total of eight groups (arrays), with each array configured
separately by individually selecting each group on the Leica SF C1.
Note:
In the following, "array" denotes all flash units within a group, no
matter if the group contains only one or several flash units.
Selecting an array
You can optionally configure all arrays simultaneously or individual-
ly. The relevant arrays must be switched on or off accordingly.
Only arrays that are switched on can be configured. The configura-
tions will be applied to all arrays with switched on devices
simultaneously, which means that devices that should not be
configured must be switched off.
1. Press the desired array button
• The relevant array letter will flash.
2. Press the button 3
• An array that is switched off will appear as
LCD panel instead of the current settings.
3. Press the array button again
• The relevant array letter will light permanently.
Switching on an array is the same procedure.
• The display for an active array appears with the relevant settings
after the second step (instead of
Notes on operation with the Leica SF 60:
• Please read the manual for instructions on how to select an
array via the flash unit.
• Array D is unavailable.
5
on the
- - - -
).
- - - -
EN
15