Operation - Extech Instruments EM100 User Manual

Operation

Do not use this instrument if it appears damaged, no longer works correctly, has been
stored for a long period under unfavorable conditions, or has been placed under heavy
stresses in transport. Remove this device from operation in the event that the instrument
has been deemed unsafe to use.
Note: To program the settings, the unit must be plugged into a 120V outlet.
Initial Setting Mode
The instrument automatically enters the Setting Mode when the battery is inserted for the
first time. Afterwards, during operation, the user can simultaneously press the MODE and
the right arrow button for at least two seconds to access this Setting Mode.
A. ID Setting
1. While the ID digit is flashing, use the "UP/DOWN" arrows to
select the desired number (0 to 9)
2. Press the "MODE" button to save the ID. The display will
automatically change to the next programmable parameter.
B. Time Setting
Before setting the time, the desired time format must be selected. Use the "UP/DOWN"
arrows to select the 12-hour format or the 24-hour format. Press the "MODE" button to
save the date format. Use the "UP/DOWN" arrows to adjust "mm.dd yyyyy" or the
"dd.mm yyyy" format. Press the "MODE" button to save the
setting and set the time.
1. While the hour digits are flashing, use the "UP/DOWN" arrows
to select the desired hour.
2. Press the horizontal arrow button to go to the next pair of
digits. Repeat this method until the time is set correctly.
3. Press the "MODE" button after setting the year (the year still
flashing) to save the setting and start the clock.
C. Cost Settings
1. While a currency is flashing, use the "UP/DOWN" arrows to
select a different currency. Available currencies are dollars ($),
Euros (€), SFr, and Pounds (£).
2. Press the "right arrow" button to go to the first cost digit.
3. While the first cost digit is flashing, use the "UP/DOWN"
arrows to select the desired number.
4. Press the "right arrow" button to move to the next digit. Repeat
this procedure until the costs are set correctly.
5. Press the "MODE" button after setting the last digit of cost 2 (while it is still flashing)
to save the setting and start the unit.
4
EM100 V2.0 07/09