Sensitech TempTale 4 Instructions For Use

Probeless dry ice monitor

Hide thumbs Also See for TempTale 4:

Enlarged version

Millions Depend on the Integrity of Your Product.

Sensitech's Mission is to Ensure that Integrity.

The Tools That Turn Information Into Power

TempTale

4 Probeless

Dry Ice Monitor

Instructions For Use

TempTale Manager

Data Management Services

RF Monitoring

Desktop Software

TempTale

4 Monitor

TempTale

4 USB Monitor

TagAlert

Indicator

For more information, contact our client services

group at 800-843-8367.

Sensitech Inc. • 800 Cummings Center, Suite 258X • Beverly, MA 01915

1-800-843-8367 • +1-978-927-7033 • Fax 978-921-2112 • www.sensitech.com

T83000610 Rev. D 07/09/14

Table of Contents

Do you have a question about the TempTale 4 and is the answer not in the manual?

Page 1: Instructions For Use
® For more information, contact our client services group at 800-843-8367. Sensitech Inc. • 800 Cummings Center, Suite 258X • Beverly, MA 01915 1-800-843-8367 • +1-978-927-7033 • Fax 978-921-2112 • www.sensitech.com © 2014 Sensitech, Inc. All Rights Reserved. T83000610 Rev. D 07/09/14...
Page 2 4. Lowest temperature recorded ice prior to closing and labeling the shipping container. • Now your dry ice shipment is ready for shipping. 5. Total time below low temperature limit • If your monitor has been programmed with a Start-up delay the Alarm monitor will not begin recording data until the Start-up delay has passed. When the TempTale4 Probeless Dry Ice monitor is exposed to a temperature outside a pre- Receiving a TempTale 4 Probeless Dry Ice Monitor programmed limit and time threshold, an “Alarm bell” will appear in the lower right corner • Important: Always use protective gloves and caution when removing the TempTale4 of the LCD display. Probeless Dry Ice monitor from the –80°C dry ice environment. Stopping a TempTale4 Monitor • When the dry ice shipment arrives, the Receiver should remove the TempTale4 Probeless Dry Ice monitor and press the Red/right Stop button to manually stop the unit. Press and hold (1 to 3 seconds) the Stop button until the “Stop sign” icon appears in the up- • Verify that the stop sign icon appears on the LCD panel indicating the TempTale4 Dry Ice...