Advertisement
Wireless Occupancy Sensor, Wall
Mount (WOS2-WM)
Daylight Hold-Off
Wireless Occupancy Sensor, Model: WOS2-WM
Power Supply: Battery ER14505 AA 3.6V (2)
FCC ID: NRH-ZB-Z100B
IC: 8984A-Z100B
ICES/NMB-003 CLASS B
FOR INDOOR USE ONLY
IEEE Address:
7.Exit Installation Test Mode. Momentarily press the
Utility button again, or wait 5 minutes for the mode to
time out .
8.The sensor attempts to join a ZigBee network for
up to 30 seconds. If it is able to join, the Network LED
turns on solid for 10 seconds. If it is unable to join, it
automatically retries every 15 minutes until it succeeds
in joining a network. Note, the sensor will not be able
to join a network until a Wireless Area Controller (WAC)
LED Operation
is commissioned. See
ZigBee Network.
LED Operation
Green LED: Network
Description
Indicator
Rapid flash (12��times
Device is trying to join ZigBee network. If it
per second) for up to 30
fails to join, it will retry after 15 minutes.*
seconds
Device successfully joined a ZigBee
Solid for 10 seconds
network.
Utility button was pressed to initiate
Flashes once
Installation Test Mode.
Utility button was pressed for 2 seconds
Flashes twice
and the device is currently joined to a
network.
On for 2 seconds every
The batteries are low; replace the
30 seconds
batteries. Also, see alert on CSM.
PIR
Swivel
Mount
Collar
20120412
Compartment
Cover (press
arrows then
slide down
00137A000000-0000
to open)
Joining the
and
Red LED: Installation Test
Description
Mode, Motion
While unit is in
The red LED flashes each time sensor
Installation Test Mode,
detects occupancy. Test mode times out
Flashes
after 5 minutes.
Normal operation: either not detecting
occupancy, or detected occupancy and
Off
in Off Delay. LED turns on with initial
occupancy.
* A network join can be retriggered manually at any time
using one of the following methods:
Reset to factory defaults: This causes the device to
•
leave any network to which it is currently joined.
Following the reset , the device attempts to join a
network. Press and hold the Utility button for
5 seconds. Release the button when the Network
LED begins to flash rapidly.
Activate device: Press and hold the Utility button
•
for 2 seconds. If the device is already joined to a
network, the Network LED flashes twice. If the
device is not joined to a network, the Network
LED flashes rapidly and the device will attempt to
join a network.
For more information about configuring the lighting
control network, see the instructions and on-line help
provided with the CSM application.
Joining the Zigbee Network
After successfully completing the Installation Test the
occupancy sensor is ready to communicate with the
Daintree Wireless Area Controller (WAC) and the Daintree
CSM web-based lighting management user interface.
For more information about configuring the lighting
control network, see the instructions and on-line help
provided with the CSM application.
2
Advertisement
