Current WIT100 Installation Manual

Installation Guide
WIT100 Sensor
Wireless Integrated Thread Sensor

BEFORE YOU BEGIN

STOP
Read these instructions completely and
carefully.
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal
RISK OF FIRE
• Follow all relevant IEC or UL instructions and local building codes
To ensure the product warranty is valid, please ensure all installation instructions and environmental conditions for storage and operation are
complied with.
Only GE trained contractors can install the product.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada license exempt RSS standards. Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme aux normes RSS exemptées de licence de Industrie Canada.
Son fonctionnement est soumis aux deux conditions suivantes:
• Cet appareil ne doit pas provoquer d'interférences et
• Cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
To satisfy FCC/ISED RF exposure requirements a separation distance of 20 cm or more must be maintained between the antenna of this device
and persons during operation. Operation at closer than 20cm is not permitted
Pour être conforme aux limites d'exposition aux ondes RF des normes FCC/ISED, une distance de séparation d'au moins 20 cm doit être main-
tenue entre l'antenne de cet appareil et toute personne pendant son opération. Mettre en opération cet appareil a une distance plus rappro-
chée que 20 cm n'est pas permis.
WARNING
IMPORTANT
FCC / IC COMPLIANCE STATEMENTS
In case of Digital bus miswiring mains can present on
the device. Make sure all electricity switched of before
inspection.