Beko BCT75GX User Manual page 14

m~;~~~~:~i~~:~~n~~;~h~n pt~o~~~~~~~~ 1 t he
mains supply.
There is the risk of electric shock!
m
Power cable plug must be within easy reach
after installation (do not route it above the
hob).
Plug the power cable into the socket.
Gas connection
ANGER:
roduct can be connected to gas supply
system only by an authorised and qualified
person or technician with licence.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held responsible for
damages arising from procedures carried out
by unauthorised or unlicensed persons.
\Before starting any work on the gas
installation, disconnect the gas supply.
There is the risk of explosion!
• Gas adjustment conditions and values are stated
on labels (or ion type label).
mour product is equipped for natural gas
(NG).
• Natural gas installation must be prepared before
installing the product.
• There must be a pipe (Piping advised to be
buyed from a licensed installer), must comply
with local gas standard, at the outlet of the
installation for the natural gas connection of your
product and the tip of this pipe must be closed
with a blind plug. Service Representative will
remove the blind plug during connection and
connect your product by means of a straight
connection device (coupling).
• Make sure that the natural gas valve is readily
accessible.
• If you need to use your product later with a
different type of gas, you must consult the
Authorised Service Agent for the related
conversion procedure.
Installing the product
1 . Remove burners, burner caps and grills on the
hob from the product.
2. Turning the hob upside down, place it on a flat
surface.
14/EN
3. In order to avoid the foreign substances and
liquids penetrate between the hob and the counter,
please apply the putty supplied in the package on
the contours of the lower housing of the hob but
make sure that the putty does not overlap.
4. Fill the corners by forming bends at the corners as
illustrated in the figure. Form as much bend as
5.
6.
ired to fill the in the corners.
1
Hob
2 Screw
3 Installation clamp
4 Counter
hen installing the hob onto a cabinet, a shelf
must be installed in order to separate the
cabinet from the hob as illustrated in the above
figure. This is not required when installing onto
a built-under oven.
For example, if it is possible to touch the bottom of the
product since it is installed onto a drawer, this section
must be covered with a wooden plate.
m1n. 15 mm