Table of Contents
Advertisement
Installation must be in accordance with this instruction
manual, AS 5601.1 'gas installations' for installation
and pipe sizing, local gas fitting regulations, municipal
building codes, local electrical regulations and any
other statutorJ regulation by an authorised person.
NOT FOR USE IN MARINE CRAFT, CARAVANS OR
MOBILE HOMES, unless each burner is fitted with a
flame safe uard.
(!)
Preparation of location and electrical and
gas installation for the product is under
customer's responsibility.
ANGER:
he product must be installed in
1
'--.:..._,accordance with all local gas and/or
electrical regulations.
m::~~~"':~~=:~~o;,'~'nm
12/EN
have it installed.
Damaged products cause risks for your
safety.
Before installation
The hob is designed for installation into commercially
available work tops. A safety distance must be left
between the appliance and the kitchen walls and
furniture. See figure (values in mm).
•
It can also be used in a free standing position.
Allow a minimum distance of 750 mm above the
hob surface.
•
(*)
If a cooker hood is to be installed above the
cooker, refer to cooker hood manufacturer'
instructions regarding installation height (min
650 mm)
•
Remove packaging materials and transport locks.
•
Surfaces, synthetic laminates and adhesives
used must be heat resistant (1 00
ac
minimum).
•
The worktop must be aligned and fixed
horizontally.
•
Cut aperture for the hob in worktop as per
installation dimensions.
•
Hob dimensions are 51
Ornrn
x 580mm. Gas
inlet is located at the rear right hand side.
Electrical terminal is located at the rear centre.
•
Must be installed by an authorised person in
accordance with AS5601 (gas installations), local
and
other
Advertisement
Table of Contents
