Hide thumbs Also See for MOB1:

Advertisement

Quick Links

7.7
Limited Warranty
Your Ocean Signal MOB1 is warranted against manufacturing defects in materials and
workmanship for a period of 5 years from the date of purchase and in accordance with the
following conditions.
Ocean Signal will at its discretion, repair or replace faulty product free of charge excluding
the cost of shipping. Proof of purchase shall be required in order for a warranty claim to
be valid from the original purchaser. All claims shall be made in writing to Ocean Signal or
an approved service dealer or distributor.
Ocean Signal shall not be liable to the buyer under the above warranty:
for any repairs or modifications carried out on the MOB1 using parts that are not
supplied or approved by the manufacture Ocean Signal including batteries and for
work carried out other than by Ocean Signal or approved service dealers,
for any part, material or accessory that is not manufactured by Ocean Signal the
consumer will be covered by the guarantee / warranty offered to Ocean Signal by the
manufacturer or supplier of such a component,
for product which has not been fully paid for,
for any product supplied by Ocean Signal to a customer under an alternative warranty
or commercial agreement,
for the cost of shipping product to and from the customer.
The Battery is only warranted until the date of expiry and provided the unit is tested in
accordance with the information in the user manual. This warranty does not apply to a
used battery as indicated by the electronic witness (see section 6.1).
The following specific item is excluded from this warranty:
Damage to the antenna
This warranty does not affect your statutory rights. This warranty is to be interpreted
under English law.
For further assistance please contact our Technical Service Department.
Email: service@oceansignal.com
MOB1 USER MANUAL
18
Part No 912S-01517
IN CASE OF EMERGENCY
Use only in situations of grave
or imminent danger
If the MOB1 is correctly fitted to the life jacket, then the MOB1 will automatically
activate when the life jacket inflates. This guide shows how to manually activate
the MOB1.
Slide the red Arming Tab down (1)
Slide the grey Activation Slide (2) sideways by pulling on the
attached tape and remove. This will release the antenna and
activate the MOB1
If the strobe light does not start flashing, manually switch the
MOB1 on by pressing the ON Key (3)
Always turn off the MOB1 immediately after you have been rescued to avoid
interference with other users. Refer to section 5.4 for deactivation instructions.
MOB1 USER MANUAL
1
2
3
3
Version 01.00 13/02/2015

Advertisement

Table of Contents
loading

Summary of Contents for Ocean Signal MOB1

  • Page 1 Proof of purchase shall be required in order for a warranty claim to be valid from the original purchaser. All claims shall be made in writing to Ocean Signal or If the MOB1 is correctly fitted to the life jacket, then the MOB1 will automatically an approved service dealer or distributor.
  • Page 2: Table Of Contents

    MOB1 USER MANUAL CONTENTS Approvals IN CASE OF EMERGENCY........................... 3 The MOB1 is approved for use in the USA under CFR47 part 95K, and approved in Canada GENERAL ........................... 5 with AIS only under RSS287. Introduction..........................5 Exposure to RF Electromagnetic Energy .................. 5 7.6.1...
  • Page 3: General

    The rescueME range of products provides the user with the latest technology specifically Baud rate ..........................9600baud designed for compact size and ease of operation. The MOB1 is intended to alert your Synchronisation ........................... UTC vessel in the event that you fall overboard. It will then plot your location on a suitable AIS Messages ...............Message 1 (Position), Message 14 (MOB status)
  • Page 4: Mob1 Overview

    The MOB1 contains Lithium metal batteries for long operating life. Your battery must be TEST/OFF Key replaced either prior to the expiry date or after the MOB1 has been used, even if only activated for a short period of time. Battery replacement must be carried out at an Ocean Arming Slide (in armed position) Signal authorised battery replacement centre.
  • Page 5: Life Jacket Installation

    LED. The strobe will flash and the indicator LED will flash green or amber to show through the slot in the a pass or red to show fail status, as indicate in Table 1. The MOB1 will then automatically activation clip and pass the turn off.
  • Page 6 Pass the tape around the bladder of the life jacket and clip the bracket to the MOB1 so that the MOB1 will be on the outside Routine testing of your MOB1 once a month is recommended to ensure it is in good of the inflation tube as shown.
  • Page 7: Mmsi Configuration

    (Applies to DSC enabled units only) To deactivate your MOB1 after use or if it is accidentally activated, press the TEST/OFF Key To be able to send DSC messages to your vessel, the MMSI number of the vessel needs to until the LED flashes red twice, then release.
  • Page 8: Operation

    Slide the grey Activation Slide to the Left or Right. The strobe light will start flashing. The MOB1 will automatically start transmitting after 15seconds. • If the MOB1 fails to activate when the slide is removed, press the ON Key down until the green LED starts flashing. Release the key. •...

Table of Contents