Serial Port Flow Control - Diamond SupraExpress 56e Manual

&C
&D
&F
&G
&K
58
Data-Carrier-Detect (DCD) Signal
Control
DCD signal always on.
DCD follows carrier. (ON when carrier from remote modem is present.)
Modem Reaction to DTR on-to-off
Modem reaction to DTR on-to-off transition greater than S25 setting. Modem WILL dial when
DTR is ON or goes from an OFF to ON state.
a b
&DØ N 2
=
3 3
&D1=
1 1
&D2=
4 4
&D3=
List of modem reactions:
N=No Action
1=Hang up if off-hook and autoanswer is disabled.
2=Hang up if off-hook and autoanswer is not disabled.
3=Switch to asynchronous command state.
4=Perform soft reset (like ATZ, profile is set by &Y).
List of &Q states:
a. &QØ, &Q5, &Q6
b. &Q1, &Q4
c. &Q2, &Q3
Load Factory Default Configuration
&FØ Restore factory configuration (default for PCs); with hardware flow control, error
correction and data compression active.
&F1 Restore factory configuration (default for MACs), with hardware flow control, error
correction and data compression active.
Note: For Direct Connect Mode, use AT\N1 &KØ &Q6 &D2.
Guard Tone Selection
Set automatically based on ATi6 setting.
&GØ Do not generate guard tones (US default).
&G1 Generate 550Hz guard tone (not supported).
&G2 Generate 1800Hz guard tone (World Wide support models only).

Serial Port Flow Control

&KØ None
&K3 Enable bidirectional hardware (RTS/CTS) flow control (default with &FØ and &F1).
&Qn
c (Settings of )
1
1
1
1