Error Correction Result Codes - Diamond SupraExpress 56e Manual

Enabled when originating; disabled when answering.
Sr? Read S Registers
Reports the value in S register r.
Sr=n Write S Registers
Writes value n into S register r.
Sr.b=n Write to S Register bit b
Writes value n (0 or 1) to bit b of S register r.
SCr? Read SC Register
Reports value in SC register r.
SCr=n Write to SC Register
Writes value n into SC register R.
T Set Dialing Mode to Tone
V Verbose/Numeric Result Codes
Numeric Result Codes.
Verbose Result Codes (default).
W Error Correction Result Codes
CONNECT XXXX (DTE - computer rate)(default).
Report error correction mode.
CONNECT XXXX (DCE - transmit rate).
X Dialing Mode/CONNECT Result Codes
Blind dial (ignore dial tone and busy signal) and send CONNECT (no rate) when
connected.
Blind dial; send Result Codes set by Wn and S95.
Wait for dial tone before dialing; do not detect busy signal; send Result Codes set by
Wn and S95 when connected.
Follow busy signal but ignore dial tone; send codes set by Wn and S95 when
connected.
Send codes set by Wn and S95 when connected. Send BUSY code if busy signal
detected; send NO DIALTONE code if dial tone is not received (default).
Y Long Space Disconnect
YØ Disable long space disconnect before on-hook (default).
Y1 Enable long space disconnect before on-hook.
Z Soft Reset and Load Stored Profile n
ZØ Reset modem and load stored profile 0.
Z1 Reset modem and load stored profile 1.
(If no NVRAM, resets to factory default.)
57