Hayward H135ID Service & Installation Manual page 5

Pool and spa / hot tub heaters
Table of Contents

Advertisement

WARNING – Failure to remove pressure test plugs and/or plugs used in winterization of the pool/spa
from the suction outlets can result in an increase potential for suction entrapment as described above.
WARNING – Failure to keep suction outlet components clear of debris, such as leaves, dirt, hair, paper
and other material can result in an increase potential for suction entrapment as described above.
WARNING – Suction outlet components have a fi nite life, the cover/grate should be inspected fre-
quently and replaced at least every ten years or if found to be damaged, broken, cracked, missing, or
not securely attached.
WARNING – All suction and discharge valves MUST be OPEN when starting the circulation system.
Failure to do so could result in severe personal injury and/or property damage. All drains and suction
outlets MUST have properly installed covers, securely attached using the screws supplied with the
covers. If screws are lost, order replacement parts from your supplier.
WARNING – Hazardous Pressure. Pool and spa water circulation systems
operate under hazardous pressure during start up, normal operation, and after
pump shut off. Stand clear of circulation system equipment during start up. Fail-
ure to follow safety and operation instructions could result in violent separation of
the pump housing and cover due to pressure in the system, which could cause
property damage, severe personal injury, or death. Before servicing pool and spa
water circulation system, all system and pump controls must be in off position and
fi lter manual air relief valve must be in open position. Before starting system
pump, all system valves must be set in a position to allow system water to return
back to the pool. Do not change fi lter control valve position while system pump is
running. Before starting system pump, fully open fi lter manual air relief valve. Do
not close fi lter manual air relief valve until a steady stream of water (not air or air
and water) is discharged.
WARNING – Separation Hazard. Failure to follow safety and operation in-
structions could result in violent separation of pump components. Strainer cover
must be properly secured to pump housing with strainer cover lock ring. Before
servicing pool and spa circulation system, manual air relief valve must be in open
position. Do not operate pool and spa circulation system if a system component is
not assembled properly, damaged, or missing. Do not operate pool and spa circu-
lation system unless fi lter air relief valve body is in locked position in fi lter upper
body.
WARNING – Never operate or test the circulation system at more than 40 PSI.
WARNING – Fire and burn hazard. Motors operate at high temperatures and if they are not properly
isolated from any fl ammable structures or foreign debris they can cause fi res, which may cause severe
personal injury or death. It is also necessary to allow the motor to cool for at least 20 minutes prior to
maintenance to minimize the risk of burns.
WARNING – Failure to install according to defi ned instructions may result in severe personal injury or
death.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN
Tel: 908-355-7995
www.hayward-pool.com
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Abg135

Table of Contents