Table of Contents
Advertisement
Quick Links
PIRHL60 Range
MODELNO.
874/2012
LAMP REPLACEMENT:
• Switch off the electricity at the mains.
• Release front diffuser cover with screwdriver.
• Remove and replace lamp making sure it seats
correctly in the lampholder.
• Replace front diffuser cover.
• Restore power.
REPLACEMENT LAMP TYPE:
Requires 1 x suitable ES energy saving lamp (not
included).
Fitting is rated at 60W max.
Email: sales@eterna-lighting.co.uk / technical@eterna-lighting.co.uk
www.eterna-lighting.co.uk
Visit our website:
Issue 0717
SPECIFICATIONS:
• Detection range: Approx. 120° (horizontal),
Max. 12 metres.
• Duration time: from 3 min ± 20 sec.
• Factory preset PIR - no override facility.
CLEANING:
To avoid dust build-up and ensure proper
functioning of the half lantern light, please wipe the
sensor lens lightly with a damp cloth every 3 months.
Disconnect the power and clean the exterior only of
this fitting with a moist (not wet) cloth.
Do not use any chemical or abrasive cleaners.
EVENTUALLY, YOU MAY WANT TO
REPLACE THIS PRODUCT:
Regulations require the recycling of Waste from
Electrical and Electronic Equipment (European
"WEEE Directive" effective August 2005—UK
WEEE Regulations effective 2nd January 2007).
Environment Agency Registered Producer: WEE/
GA0248QZ.
WHEN YOUR PRODUCT COMES TO THE END OF
ITS LIFE OR YOU CHOOSE TO REPLACE IT, PLEASE
RECYCLE IT WHERE FACILITIES EXIST - DO NOT
DISPOSE WITH HOUSEHOLD WASTE.
IF YOU EXPERIENCE PROBLEMS:
If you believe your product is defective, please return
it to the place where you bought it. Our Technical
Team will gladly advise on any Eterna Lighting
product, but may not be able to give specific
instructions regarding individual installations.
Made in China
Installation INSTRUCTIONS
A guide for qualified electricians
Model:
PIRHL60BK / PIRHL60WH
Half Lantern with 120° PIR
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR NEW FITTING
PLEASE RETAIN FOR FUTURE REFERENCE
Pack contents:
• Half lantern with 120º PIR
• Mounting fixtures
Advertisement
Table of Contents
Related Manuals for Eterna PIRHL60BK
Summary of Contents for Eterna PIRHL60BK
- Page 1 Our Technical • Release front diffuser cover with screwdriver. Team will gladly advise on any Eterna Lighting • Remove and replace lamp making sure it seats product, but may not be able to give specific correctly in the lampholder.
- Page 2 120˚ 6) Replace and secure the plastic PIR cover. it. Eterna lighting cannot accept any liability for Appr. loss, damage or premature failure resulting from 7) Insert suitable ES energy saving lamp.
- Page 3 TROUBLESHOOTING AND USER HINTS: Note: all passive infra red detectors are more sensitive in cold and dry weather than warm and wet weather. PROBLEM POSSIBLE CAUSE SUGGESTED REMEDY 1. No mains voltage Check all connections, and MCB Fuses / switches 2.
Need help?
Do you have a question about the PIRHL60BK and is the answer not in the manual?
Questions and answers