Printed Wiring Boards -Cd Mechanism Section - Sony CDX-3900R Service Manual

CDX-3900R/4000R/4000RX
Q Q
3 7 6 3 1 5 1 5 0
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
for schematic diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• % : indicates tolerance.
• : internal component.
f
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• U : B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : FM
f : MW
J
: CD
for printed wiring boards:
• X : parts extracted from the component side.
T E
• Y : parts extracted from the conductor side.
L 1 3 9 4 2 2 9 6 5 1 3
• : parts mounted on the conductor side.
x
• : Through hole.
a
• b : Pattern from the side which enables seeing.
(The other layer's patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
w w w
3-6. PRINTED WIRING BOARDS — CD MECHANISM SECTION —
x a o
y
. i
http://www.xiaoyu163.com
8
Q Q
3 7 6 3
u 1 6 3
.
24 24
http://www.xiaoyu163.com
2 4
9 9 8
1 5 1 5 0 8 9 2 4
m
c o
2
9 9
9 8 2 9 9