Reynolds Building Systems the Easton Assembly Manual page 10

Step 6B Assemble Back Walls for 20' Building Length
1. Select the 10' wall frame, without siding, assembled in Step 6A. Position this wall frame,
against the wall panel so the 72" section is against the sided panel as shown below.
DO NOT nail these frames together so they can be separated later.
2. Square the wall frame. Install a full width siding panel but do not nail along the long edge
that overlaps the 10' wall frame. You can nail this edge after the wall panels are installed.
This will enable you to separate the wall panels making them easier to handle.
3. Install another full width siding panel and
the 24" wide siding panel.
Do Not Nail Along This Edge
10' Wall Panel from Step 6A
72" Wall Plate
48" Wall Plate