Important Safety Instructions - Sanyo FW40D48F Owner's Manual

Led backlight
Table of Contents

Advertisement

Important safety instructions

1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with dry cloth.
7.
Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
8.
Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9.
Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10.
Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11.
Only use attachments / accessories specified by the
manufacturer.
12.
Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the
apparatus. When a cart is used, use
caution when moving the cart /
apparatus combination to avoid injury
from tip-over.
Wall mount bracket kit
Brand
SANUS
FW40D48F
Your TV meets the VESA standard for wall mounting. Consult with
your local dealer for a wall mount bracket which is compatible with
your TV model.
The recommended wall mount bracket kit (sold separately) allows
the mounting of the TV on the wall.
For detailed information on installing the wall mount, refer to the
wall mount Instruction book.
Funai is not responsible for any damage to the product or injury
to yourself or others if you elect to install the TV wall mount
bracket or mount the TV onto the bracket on your own.
The wall mount bracket must be installed by experts.
Model #
Screw dimension
SAN25BB M6 x 0.472" (12mm)
13.
Unplug this apparatus during lightning storms or when
unused for long periods of time.
14.
Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate
normally, or has been dropped.
Note to the CATV system installer:
This reminder is provided to call the CATV system
installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.
Example of antenna grounding as per NEC -
National Electric Code
GROUND CLAMP
ELECTRIC SERVICE EQUIPMENT
Funai is not liable for these types of accidents or injuries noted
below.
Install the wall mount bracket on a sturdy vertical wall.
If installed onto a ceiling or slanted wall, the TV and wall mount
bracket may fall which could result in a severe injury.
Do not use screws that are longer or shorter than their specified
length. If screws too long are used this may cause mechanical or
electrical damage inside the TV set. If screws too short are used this
may cause the TV set to fall.
Do not fasten the screws by excessive force. This may damage
the product or cause the product to fall, leading to an injury.
For safety reasons use 2 people to mount the TV onto a wall
mounting bracket.
Do not mount the TV onto the wall mounting bracket while your
TV is plugged in or turned on. It may result in an electrical shock
injury.
When installing the unit on the wall, allow this much
space.
: 11.8 inches (30cm)
Top
: 5.9 inches (15cm)
Left and right side
: 3.9 inches (10cm)
Bottom
ANTENNA LEAD IN WIRE
ANTENNA DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM (NEC ART 250,
PART H)
4
.
English

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents