Pairing The Home Rtx With Another Device - Miccus BBRTX-01 Quick Start Manual

PairingtheHomeRTXwithanotherDevice
The pairing process creates a Bluetooth® bridge between a Bluetooth®
transmitter and a Bluetooth® receiver. The versatile Home RTX can
function as either a Bluetooth® transmitter OR receiver. The pairing
process should take approximately 5-10 minutes.
For quicker, easier pairing:
Verify the RTX has power and audio connections completed
•
Make sure the RTX and your Bluetooth® device are physically
•
located near each other during the pairing process, no more
than 3ft apart.
Make sure any previously paired device, Bluetooth®
•
headphones, speakers, adaptors are turned off so the RTX is
ready to look for a NEW device to pair to.
Please follow the below steps in a timely manner, without
•
interruptions for best results.
TransmitMode(TX):
1. Power on and start the pairing mode on your receiving device,
i.e. Bluetooth® enabled headphones, speaker or other compati-
ble A2DP Bluetooth® profile device.
2. Power on the Home RTX: press and hold the power button
(3 seconds) until the indicator light begins flashing.
3. Press and hold the RX button for 3 seconds and release; the
light will flash red and blue indicating it is in pairing mode.
4. Double Press the TX button (2 clicks) the red and blue indicator
light is briefly interrupted, then flashes red and blue again
indicating it is in pairing mode.
5. WAIT for the devices to connect. This may take up to a minute.
6. When pairing is complete, the RTX light will be solid red.
7. To begin streaming wireless audio, simply press play on your
audio source, adjust the volume to preference and enjoy!
6