Lcd Display Screen; Powering 12V Dc Devices; Led Flashlight - SJS + Smart Jump Start Charger SJS3000 PRO Series User Manual

LCD DISPLAY SCREEN (2)

The LCD Display Screen reads Power Pack Voltage 0% to 100% . To check the Power
Pack charge capacity at any time by switching the ON/OFF Switch (7) to ON . The LCD Dis-
play Screen will illuminate and show the percentage number . After 3 seconds the back-
light will go off . If not using the Power Pack for Digital device charging the LCD Display
Screen will turn off due to power saving mode .
When charging digital devices the LCD Display Screen will initially illuminate then the
backlight will go off but the charge indicator percentage will still be showing . To illuminte
the LCD Display Screen at any time push the Mode Switch (4) once .
CHARGING DIGITAL DEVICES
USB 5V 2.1A /1A
Check the charging requirement voltage and current for your device from the manufacturer
specification . Switch the ON/OFF Switch (7) to ON . The LCD Display Screen (2) will illu-
minate. Plug the USB 2 in 1 Adaptor Cable (E ) into either of the USB Digital Charge Ports
(5a) (5b). Select 1 or 2 of the adaptors on the cable and plug into the charge port of your
digital device . You can also use the original USB charge cable supplied with your device .
NOTE : Some brands of phones or tablets have blocking software not allowing non genu-
ine cables to charge your device . Adjust the settings on the device to unblock the soft-
ware .
MULTI VOLT CHARGING
12V 2.5A / 16V 3.5A / 19V 3.5A
Check the charging requirement voltage and current for your device form the manufacturer
specification .
The SJS3000 kit comes with Multi Volt Charging Cable with 8 Adaptors (F) . Turn the ON/
OFF Switch (7) to ON . The LCD Display Screen (2) will illuminate . Push the Mode Switch
(4) once and 12v will appear in the bottom of the screen . Push Mode Switch once more
for 16v and once more for 19v . Once you have selected the correct voltage for your de-
vice plug the Multi Volt charging cable with the suitable adaptor into the charge port of
your device . The LCD Display Screen backlight will turn off but the numbers will stay .
NOTE : Some Laptops and other larger devices have large battery capacity . It may in
some cases the SJS3000 Power Pack will not be able to fully charge your device .

POWERING 12V DC DEVICES

The SJS3000 Power Pack is able to power 12v devices up to 180watts 15Amps . Lift the
rubber flap over the Jump Port (8) . Plug the EC8 to EC5 Adaptor (D) into the jump port .
Plug the SSCFCL Female Cig Lighter Adaptor ( optional accessory not supplied) into the
EC5 connector . Connect your device via a male cig lighter plug into the SSCFCL156. you
can check the Power pack capacity at any time by switching the ON/OFF Switch (7) to ON
and the LCD Display Screen will show remaining capacity . To power 12v device from the
Jump Port the ON/OFF does not necessarily have to be ON . DO NOT USE ANY OTHER
FORM OF PLUG OR CABLES CONNECTED TO THE JUMP PORT OTHER THAN GENUINE SJS
ACCESSORIES .

LED FLASHLIGHT (1)

The LED flashlight (1) has 3 modes . Switch the ON/ OFF Switch (7) to ON . Push the Mode
Switch (4) and hold for 3 seconds for FULL push Mode Switch again for S.O.S. push Mode
Switch again for EMERGENCY FLASH . Push and hold Mode Switch for 3 secs to turn off .
5