Alpine PDP-E800DSP Owner's Manual page 15

USB Driver Installation
After the software installation was done, the USB
driver needs to be installed. During this process,
the amplifier must be disconnected from the PC.
You will eventually see a Windows security
warning. Continue the driver installation by
selecting: 'Install this driver anyway' .
Caution:
It is highly recommended to set the volume of
your car source to minimum position during the
first start-up. Additionally, no devices or
speakers should be connected to the amplifier
until general settings in the Alpine Sound Lab
for PDP-E800DSP software have been made.
Especially when the PDP-E800DSP is used to
drive a fully active speaker system. Wrong
settings can destroy your tweeters right away.
Connect your PC to the PDP-E800DSP:
• Connect your PC with the supplied micro
USB cable.
USB RC WIFI
OPT IN
PROT
STAT
PC
LINK
• If you haven't done so, connect power to
the PDP-E800DSP.
• Start the software by double clicking the
Alpine Sound Lab for PDP-E800DSP Icon
on your PC.
• To activate communication to the
PDP-E800DSP simply press the power icon.
The power icon will also change from
being grey to being blue
Not Connected
Connected
Select „Yes" in the pop-up window. The DSP amp
is now ready for the system configuration to be
started.
15
-EN