Pride Mobility 614 Owner's Manual page 24

I I I . B AT T E R I E S A N D C H A R G I N G
1.
4
2
3
2
Figure 14. Battery Removal/Installation Terminals and Connections
4. Disconnect the battery cables from the battery
terminals by sliding back the terminal boots and
unscrewing the nut from the bolt. See fi gure 15.
5. Remove the old batteries from the battery wells.
NOTE: Some scooters have spacers installed to secure
the batteries. You may want to remove the spacers for
safe keeping until the batteries are replaced in the
scooter. See fi gure 16.
6. Place a new battery in each battery well. Face the
battery terminals of each battery away from the seat
post with the positive (+) and negative (-) battery
terminals positioned as shown in fi gure 14.
NOTE: Models 614 and 714 use battery straps to secure
batteries in the battery wells. Please refer to fi gure 16 for
battery strap installing procedures.
24
IDENTIFICATION KEY
MAIN CIRCUIT BREAKER
1a. Reset Button
1b. Reset Lever
1c. Auto Reset style
1a
4
5
5
2. BATTERY TERMINALS UNDER BOOTS
3. BATTERY TIE-DOWN STRAP
4. BATTERY HARNESS CONNECTORS
5. FRONT-TO-REAR HARNESS CONNECTOR
2
3
2
3
2
2
1b
Figure 15. Battery Terminal Hardware
4
1c
Full-size Scooter Series
2
3
3
2