Pride Mobility 614 Owner's Manual page 13

SETTING
Odometer
Tripometer
Temperature
Clock
Chart 1. LCD Control Panel Information
Press MODE until the setting you want to change appears on the LED screen. Press and hold SET then follow
the steps corresponding to your setting in chart 2.
SETTING ODO
Press the MODE
button until ODO
OPERATION
option appears.
Press and hold SET,
then simultaneously
press the
button
setting
SELECTION
flashes.
through the options
by pressing the SET
button.
When desired option
flashes, press any
EXIT
button except SET
to exit.
Chart 2. LCD Control Panel Information
Battery Charging Mode
During battery charging, the console will display the clock and the battery condition indicator.
Battery Condition Indicator
When the key is turned to the "on" position, this LED indicator gives an approximate reading of battery strength.
When the scooter's battery voltage reaches a low enough level, a warning beep will sound once, indicating the
batteries need charging. The warning beep will not sound again until the scooter is restarted or the throttle control
lever is pressed.
Full-size Scooter Series
I I . Y O U R S C O O T E R
SETTING INFORMATION CHART
CODE
ODO
TRIP
TEMP
TRIP
Press the MODE
button until TRIP
option appears.
Press and
SET,
s i m u l t a n e o u s l y
MODE
until the press the MODE
option button for
Scroll seconds
release. Press and
hold
SET
Tripometer resets
to 0.0.
Press any button
except SET to exit.
Measures mph, km/h, and hours of use. Also displays total distance traveled
over life of scooter. (Cannot be reset.)
Displays trip distance traveled. Can be reset to "0".
Displays current temperature in °F or °C.
Displays time in 12-hour (AM/PM) or 24-hour.
TEMP
Press the
MODE
button until TEMP
option appears.
hold Press and hold SET,
then then simultaneously
press the
MODE
button until the
2 setting option fl ashes.
and Scroll through the
options (°F or °C) by
until pressing SET button.
When your choice is
fl ashing, press any
button except SET to
exit.
INFORMATION
Press and hold MODE button until the clock
symbol appears on screen.
Press and hold SET, then simultaneously press
the MODE button until the hour digit fl ashes.
Use the SET button to increase the hour to the
correct number. Continue to use the MODE
and SET buttons to program the minutes and
AM/PM setting.
Press any button except MODE or SET to exit.
13