Table of Contents
Advertisement
Chapter 2 Unpack and Installation
Unpack:
When unpacking the WVT-501, pleased verify that none of the components listed in
Table 3.1 are damaged or missing. If there are any components missing, please
contact your distributors or OSEE for it.
No.
Item
1
WVT-501 Transmitter(with battery plate)
2
WVT-501 Receiver(with battery plate)
3
Antenna
4
User Manual
5
Warranty Card
Installation:
Prepare for installation
1.
Please follow the procedures below before installing WVT-501:
Check the package and equipment for any visible damage that may have
occurred during transit.
Confirm all the items listed on the packing list have been received.
Remove all the packing material including electrostatic-resistant packing.
Retain these packing materials for future use.
Connect the antennas to the top side of the unit, each needs four
2.
antennas, as shown in Figure3-1. Put the antennas as fan arrangement to
transmit or receive signals more steadily.
Connect required signal cables to the corresponding interfaces.
3.
Connect the 7～17VDC power source to DC IN interface.
4.
Table 2-1 Packing List2
Figure 2-1 Antenna Interfaces
4
Unpack and Installation
Quantity
1
1
8
1
1
Advertisement
Table of Contents
