About this manual Important The following symbols are used in this manual: The further information or know-how for described subjects above which helps user to understand them better. The safety matters or operations that user must pay attention to when using this product.
Page 4
—Consult the dealer or an experienced radio/TV technician for help. Contents The user manual applies to the following device types: WVT-501 The images and descriptions of WVT-501 are adopted as examples in the following document. Before reading the manual, please confirm the device type.
1080 video signal with no compression and no delay in optimal line-of sight situations. The WVT-501 transmitter supports a SDI input or a HDMI input, and the SDI input with loop out, besides, the WVT-501 receiver supports two SDI outputs, a HDMI output.
Page 6
Overview User configurable frequency bands Support SDI/HDMI interleaving output With internal battery to achieve power switch for uninterrupted work Provide battery plate as standard configuration CNC aluminum, laser lithography, ruggedized Support TALLY input/output 2 ...
Page 7
Safety Warnings: Read, keep and follow all of these instructions for your safety. Heed all warnings. Device Install in accordance with the manufacturer's instructions. Do not beat with a hard object or scratch the unit. Refer all servicing to qualified service personnel. Servicing is required if any of the following occurs: The unit has been exposed to rain or moisture.
Unpack and Installation Chapter 2 Unpack and Installation Unpack: When unpacking the WVT-501, pleased verify that none of the components listed in Table 3.1 are damaged or missing. If there are any components missing, please contact your distributors or OSEE for it.
Page 9
WVT-501 provides not only DC powered supply mode, but also battery powered supply mode. WVT-501 provides one battery slot to connect to the battery plug on the battery plate, as shown in Figure2-2. Then connect a battery to the battery plate, thus power on the unit by battery.
Locations and Function of Parts and Control Chapter 3 Locations and Function of Parts and Control 3.1 Parts and Functions The parts of WVT-501 is shown as below, there are various input and output interfaces: WVT-501 Transmitter Figure 3.1-1 Left View of WVT-501 Transmitter Figure 3.1-2 Right View of WVT-501 Transmitter...
Page 11
It lasts about one minute for starting operation, and please don’t do any operations during starting the device. There are four antenna interfaces at the top of WVT-501 unit, and five 1/4” inch thread interfaces at the bottom. 7 ...
Locations and Function of Parts and Control 3.2 OLED Screen and Buttons It provides an OLED screen and some buttons, the details are as below: 5190 Figure 3.2-1 OLED Screen and Buttons 3.2.1 OLED Screen As shown in Figure 3.2-1, there is an OLED screen at the top right side of the unit, and it will display the signal strength, frequency point and video format.
Locations and Function of Parts and Control 3.2.3 Indicator Status There are a VIDEO indicator and a LINK indicator at the bottom of WVT-501. The different combinations of these two indicators and the different status of the unit are as the table below:...
Locations and Function of Parts and Control 3.3 Supported Signal Format Supports the following signal format for this device is as shown in Table 3.3-1: Table 3.3-1 Supported Signal Format HDMI 480P60 576P50 720P50 720P60 1080I50 1080I60 1080p24 1080P25 1080P30 1080P50 1080P60 10 ...
Specifications Chapter 4 Specifications 4.1 Production Details Specification Values Model Wireless Video Transmitter Wireless Video Receiver SDI IN(BNC) SDI1 OUT(BNC) SDI LOOP OUT(BNC) SDI2 OUT(BNC) HDMI IN(Type A) HDMI OUT(Type A) Interface Antenna(PR-SMA male) Antenna(PR-SMA male) DC IN(2pins LEMO) DC IN(2pins LEMO) TALLY OUT(3.5mm) TALLY IN (3.5mm) LINK-Green ;...
Page 16
168x107.1x27mm(without antennas) Weight 540g *The unit about the appearance attributes in above table is mm. 4.2 Dimensions The description of the WVT-501 dimensions are as shown in the following figures (Unit: mm): Wireless Video Transmitter Without Battery Plate With Battery Plate Figure 4.2-1 Front View(Unit: mm)
Page 17
Specifications Figure 4.2-2 Back View(Unit: mm) Figure 4.2-3 Side View(Unit: mm) 13 ...
Page 18
Specifications Figure 4.2-4 Top View (Unit: mm) Wireless Video Receiver Without Battery Plate With Battery Plate Figure 4.2-5 Front View(Unit: mm) 14 ...
Page 19
Specifications Figure 4.2-6 Back View(Unit: mm) Figure 4.2-7 Side View(Unit: mm) 15 ...
Page 20
Specifications Figure 4.2-8 Top View (Unit: mm) Specifications are subject to change without notice. ------------------No Text Below------------------ 16 ...
Page 21
FOR MORE INFORMATION PLEASE VISIT: http://www.osee-dig.com.cn/ OSEE TECHNOLOGY CO., LTD. (+86) 010-62434168 Tel: Fax: (+86) 010-62434169...