Advertisement
Additional Information
For additional information or troubleshooting assistance, refer to
the User Guide on the OM-CP Data Logging Software CD-ROM. You
can also call or e-mail for further support.
Website
http://www.omega.com
E-mail Support
das@omega.com
Phone
1 (800) 622-2378
Fax
(203) 359-7700
Address
Omega Engineering, Inc.
One Omega Drive
P.O. Box 4047
Stamford, CT 06907-0047
B
Connect the other end to a USB
port on your PC. When the OM-
CP-IFC200 is plugged in, the
Found New Hardware Wizard
will pop up. Select the No, not
this time option to not allow
Windows to connect to Windows
Update. Click the Next button to
B
continue.
C
When prompted for the installation
CD, select the Install the
software automatically option.
Click the Next button to continue.
N
: the CD is not necessary for
OTE
this step to complete.
C
D
When using Windows XP, a screen
may appear indicating, the
software has not passed
®
Windows
Logo testing. This
software has been tested and
works properly with Windows XP.
Click the Continue Anyway
button to complete the installation.
E
When the installation is complete,
D
the Found New Hardware
Wizard will reappear stating that
it has finished installing the
software for the USB Datalogger
Interface. Click the Finish button
to exit the Wizard.
Congratulations! The installation of
the OM-CP-IFC200 USB Datalogger
Interface is complete!
E
3
Test USB Datalogger Interface Operation
A
To verify that the OM-CP-IFC200
drivers were installed properly,
check to ensure the OM-CP Data
Logging Software can recognize
the device.
B
The blue power LED indicator light
on the OM-CP-IFC200 should be
on. If the blue LED indicator light
is
on, unplug the USB cable
NOT
from the OM-CP-IFC200. Wait 5
seconds, then plug the USB cable
into the OM-CP-IFC200.
C
Start the OM-CP Data Logging
Software.
If necessary, see the software
manual for additional information
on the software.
D
From the Communication menu
on the toolbar choose Select
Comm Port from the drop down
list.
A sub-menu will appear listing the
software available communication
ports. If the OM-CP-IFC200
installation was successful and the
device is plugged into the
D
computer, the menu option of
USB1 should appear. If multiple
OM-CP-IFC200 devices are
plugged into the same PC, they
will all be listed in this menu as
USB1, USB2, USB3, ... etc. Use
this menu to select the proper
device.
E
As with a standard COM port the
OM-CP-IFC200 must be
configured to communicate at the
proper baud rate. The OM-CP-
IFC200 can be configured to work
with most OM-CP Dataloggers by
selecting the proper baud rate in
the software. The baud rate will
be dependent on the baud rate of
E
the device connected to the host
computer. For example, an
OM-CP-TEMP101 communicates at
2400 baud, so 2400 baud must be
selected from the
Communication menu.
Advertisement
