Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for YBIKE SESSION
Summary of Contents for YBIKE SESSION
-
Page 1: Owners Manual
THE ART OF BALANCE SESSION Owners Manual... -
Page 2: Important Safety Notice
WARNING SAFETY PRECAUTIONS: The use of the YBIKE Session can be a hazardous activity and precautions should be taken to avoid dangerous situations. Be sure to read the entire manual before riding. Please pay close attention to the following notices in particular: WARNING! This ride-on is intended to be assembled by an adult. - Page 3 Never use near cars, motor vehicles, roadways, near streets or tra c. DO NOT use in tra c. º Never allow more than one child to ride on YBIKE Session at any time. Not to be used by º children weighing more than 20kgs due to insu cient strength.
- Page 4 YBIKE Session Parts List & Components Remove all of the parts from the box, lay them on the floor and check that all the components listed are there. Note: Items marked with * are pre-assembled. Part Part Name Front Fork...
-
Page 5: Rear Frame Assembly
ASSEMBLY INSTRUCTIONS 1. Rear Frame Assembly Place the Seat Bolts (No. 8) the two holes in the seat. Then place the seat on the frame, ensure that the two bolts line up with the holes in the frame. Tighten the Seat Nuts (No.9) into the bolts with the Larger Allen... - Page 6 ASSEMBLY INSTRUCTIONS 2. Attaching the Front Fork to the Body Line up the Front Fork as shown & insert Steering Bolt (No. 11) into the lower hole from underneath. Place a Plastic Stopper (No. 6) over the Front Fork Bolt (No.
- Page 7 ASSEMBLY INSTRUCTIONS 3. Attaching the Wheels to the Body Align the wheel axle with either the Top or Bottom slot of the Fork. Tighten the Wheel Bolt (No. 3.1) on both sides and ensure the Locking Washers (No. 3.2) fit into the hole in the fork.
- Page 8 ASSEMBLY INSTRUCTIONS 4. Wheel Settings The YBIKE Session has 2 wheel settings which adjust the height of the seat, as well as the wheel base. The Low setting has a seat height of 36cm. The High setting has a seat height of 40cm.
- Page 9 ASSEMBLY INSTRUCTIONS 5. Adjusting the Wheel Settings To change the wheel setting, turn the YBIKE Session upside down so that it rests on its handles & seat, on the ground. Then simply loosen the Wheel bolts (No. 3.1) on both sides of the fork so that the Locking Washer (No.
-
Page 10: Check Before Riding
This product must be assembled by an adult. Read the manufacturer’s instructions before using. Keep the instructions safe for future reference. For children age group 2-5 years. Maximum weight 20kgs. Avoid direct, high impact collisions into walls, sidewalks and other objects. Visit www.YBIKE.co.za www.YBIKEUSA.com...