MasterCool 69100 Operating Instructions

2. Sys1am wtll run until vacuum swttch shuts Sys1am arr automatlcany. PUrge may Ulk8 a
1ew mlnute9 es some llqukl refrigerant may be In the Recovery System. n,e llqukl must
become vapor. which may require some time.
3. Shut OFF Recovery System. If System Is to be used wtth the same refrigerant next
opemtion, shut outlet valve and dieconnect outlet h068. If venting of ayatem is requintd,
di8connect outlet ho8e to relieve residual Pl'888ur&.
4. The Inlet Port has a flne screen tllt8r. Remove Inlet nut and clean screen flltar aft8r 8Y8ry
Ulle. A clean flltl!r Is very Important for the proper operation of the System. Replace flltl!r
dryer whenever plugged or contaminated.
TO DRAIN RECOVERED OIL
CAUIIONI DD nat Qlfll the apen bDttl9 neckl
'Ille neck nurt Nffllln open to wnt Pr.Mn,
....,..ra1ar
NOIEI 'Ille all capaclly 111 approximately 1.5 oz wtllch can cover 8-10 nonnal
recovery, lto'Mvw, eome Qnlll'M depollt more all Ill the NP8rator due to lllgh
preaure ar excealn oil In the aptem. It 111 ntCDmmended to dn1ln all after
81Ch UN of the 19COW9l!f mactlll'le,
1. Check pl'8&8ure on recovery mactilne Inlet prassure gauge. Pname must• balDw 10 PSI
(.7 Bar}, but abawlt 2 PSI (.1 Bar}.
2. lnaert short yellow hose Into the •plastic bottle wtth two openings• wtllch Is supplled. Carefully
attach the short yellow hooe to the oil drain titting on the recovery machine. Aa h088 Is tlghtsnl'Jd
on fitting, oil will flaw into container. (Hose is equipped with a depl"N80r wtlich will open core valve
in Oil drain fitting).
& When oil has drained completely, disconnect 1he ho88 from the system. unscrew the cap,'hoee from
or
1he bottle and Cllspcse 1he oil Into an env1ronmenta11y approved con1alner.
MAINTENANCE REQUIREMENTS
1. Replace fllter H sight glass Indicator Is red/Dl'IIJ'l9 In color. The color change may be gremlblue
for dry condition when refrigerant Is passing through and red/orange In color for wet condition.
2. Replace fllter aft:llr recovering refrigerant from a known contaminated systllm.
3. Replace fllter H excessive pr888Ure drop ls Indicated. Difference of pn,ssure gauge reading before
and aftsr filler.
To connect yellow II088 from
menlfald to the ntca¥11ry, ...
provided adapt-.
Connectlon8 for llqukl/vapgr reoowry using manll'Old gauge set
-
.
-
.,......
...
69100-INST-UNN
OPERATING INSTRUCTIONS
I
REFRIGERANT RECOVERY SYSTEM
99 Washington Street
Melrose, MA 02176
Phone 781-665-1400
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
I