Led Indicators; Maintenance - AAB TempSmart TS-100 User Manual

LED Indicators

The two LED indicators flash in order to inform the user about the unit's operation. In
normal operation, the LED will flash once every second for 30 seconds to let the user
know the unit has been powered on. At the end of the first 30 seconds, the meter will
go into standby mode and will remain in standby mode as long as the meter is open.
The meter can be connected to at any time while in the standby mode without physical
interaction. Closing the meter turns it completely off.
If the battery voltage falls below 2.8 volts, the TS-100 will automatically shut down the
Bluetooth connection and will quickly flash three times every two seconds. Please see
below for instructions on changing the battery.

Maintenance

Changing the battery
Step one: Using the indentation on the top of the unit, lift to pop the battery door open.
Step two: Pull the battery door off and flip the TS-100 over to remove the battery.
Place in a new battery with the positive side facing up, as in the picture below.
Step three: Place the battery door back onto the TS-100, making sure all three clips
are firmly seated.
Cleaning
To clean the TS-100, use a dry dust free rag and wipe down exterior.
* Do not rinse or submerge! *
Storage
The ABM-200 is to be stored out of direct sunlight in temperatures between 32° and
95° F (0° and 35° C).
Shop for Data Logging products online at:
DataLoggerStore
www.
11
1.877.766.5412
.ca