Page 1
TREK Plus Battery Replacement Instructions Caution: Disconnect the TREK Plus USB charging cable and place the power switch in the OFF position before beginning the replacement. 1. Tools recommended are a TX 6 TORX driver, a very small flat bladed screwdriver, a wide bladed screwdriver and a long, needle-nosed pair of pliers.
Page 2
4. Remove the two screws on the bottom right side of the unit base using the TX 6 TORX driver. 5. The battery cover is held in place by tabs in the sides of the case. Slide the base cover of the A28 toward the left, away from the place where the two screws were removed.
Page 3
The circuitry is relative fragile, use care. 8. Replace with a battery pack from TDK Life on Record. Position the plug and battery wires to align with the socket connector. The needle nosed pliers can then be used to carefully press the plug of the new battery into the socket.
Page 4
9. Route the wires into place and press the new battery into the battery cavity. 10. Place the base cover in position to the left of the opening, engaging the tabs toward the front of the unit as shown here: 11.
Page 5
Proper disposal of the old battery is essential from an environmental and safety point of view. Please follow local regulations for proper disposal. Putting any battery directly in the trash will harm the environment. Do not incinerate. Following the replacement, the new battery should be fully charged prior to usage. Connect the Micro USB charging cable to the Charge connector of the TREK Plus (under the flap) and the other end to a USB power source.