Table of Contents
Advertisement
EN537 Smart Encoder
Cloning Live Data to Additional Encoders (Clone Add-On)
The Clone feature re-transmits all control commands and caption data to one or more additional caption
encoders. The additional encoders can be connected either through RS-232, or through the Clone TCP/IP
interface.
To determine if Clone is installed on your unit, access your encoder's web interface, look for an entry that
says Clone on the left side menu and select it. If you are prompted for a license key, the feature is not
installed and can be purchased by contacting the EEG sales team.
The master encoder must have the Clone port optional software installed, and then set up through clone
section of the web interface. When any "Clone Server" option is enabled, the encoder will copy commands
and data that are received through the dial up modem (MA), iCap, telnet, or RS-232 (P1, plus P2 if it is being
used for input and not Clone output). You can also choose to copy these commands to the RS-232 port
(Start RS-232).
Further documentation for this feature may be found at
https://eegent.com/support/resources
Figure 7: Clone Settings on the Encoder Web Interface
Copyright © 2018 EEG Enterprises, Inc.
12
All Rights Reserved.
Hide quick links:
Advertisement
Table of Contents
