Computer Source Selection - Zenith H27H49S Installation Manual

Computer Source Selection

Choosing the computer input on the Source menus
SOURCE MENU
ANTENNA/CABLE
AUX VIDEO
S-VIDEO
FRONT COMPUTER SVGA
REAR COMPUTER SVGA
COMPONENT YPrPb
PRESS TO CHANGE
< >
PRESS OR KEYS TO ACTIV.
ENTER
Selecting Viewing Sources Using
the Onscreen Menus
Source Selection Using Remote Control
A
Press TV/VCR SOURCE repeatedly on the
remote to cycle through the available
sources.
Source Selection Using Source Menu
1 Press MENU repeatedly on the remote
until the Source menu appears.
Use the Up/Down arrow on the remote
2
control, to select the computer source
that you want to appear on your screen.
3
Press Enter, or the Left/Right arrow on
the remote, to change to the new
source. Press ENTER again to remove
menu.
The front Computer In connector is an Auto
Sense input. If you connect a computer to
this connector, it will override any other
selected source and show the computer dis-
play on the screen.
If the source you want to select does not
appear as an option on the Source menu,
it may be set up as a Auto Sense input.
Sources that are specified as Auto Sense
inputs will not appear on the Source menu.
Page 12
SOURCE
FRONT COMPUTER SVGA
PRESS:
SOURCE TO CHANGE
ENTER TO ACTIVATE
Selecting Viewing Sources Pressing
TV/VCR Source Key on Remote
PRG
CABLE VCR AUX
AUDIO
FLASHBK
CHANNEL
VOLUME VOLUME
CHANNEL
1 2
4 5
7 8
0
1
MENU
2
RECORD PAUSE TIMER
PLAY
REWIND
STOP
POWER
TV
MUTE
3
6
9
3
ENTER
3
TV/VCR
A
SOURCE
FFWD