PoolRite SQI 400 User Manual

Warranty
Your new POOLRITE Quietline SQI Series Pump is manufactured to the highest possible standards and most up-to-
date technology. Accordingly the equipment carries the following warranty, should a fault occur due to faulty
manufacture or materials. In the event of a fault covered by warranty occurring, the purchaser must, in the first
instance, contact Poolrite Equipment Pty Ltd or the closest authorised distributor.
POOLRITE warrants that the Quietline SQI Series Pump will operate effectively for the specified periods subject to the
following conditions:-
1. The warranty covers the Quietline SQI Series Pump and extends to the workmanship and materials used in the
manufacture of the unit only. POOLRITE specifically disclaims any liability for any consequential loss or
damage which may result from the use of the Quietline SQI Series Pump.
2. The Quietline SQI Series Pump is warranted against manufacturing defects only for a period of 3 years from date
of purchase, in which event POOLRITE shall, as its sole operation, either repair or replace such damaged units
delivered to POOLRITE or its authorised distributor.
3. This warranty extends only to:
(i) within the borders of Australia and New Zealand.
(ii) A Quietline SQI Series Pump that is installed and maintained strictly in accordance with
POOLRITE's instructions, and/or installed by agents duly authorised by POOLRITE without alterations
or modifications of any nature whatsoever.
(iii) The Quietline SQI Series Pump returned to the distributor from which it was purchased or to POOLRITE at
the purchaser's expense.
4. This warranty excludes:
(i) Damage arising from abnormal use, lack of care, extreme exposure to the elements or chemicals or fact
beyond the control of POOLRITE.
(ii) The POOLRITE warranty supersedes all other warranties whether expressed or implied.
POOLRITE accepts no responsibility for loss, damage or injury to person or property arising from warranty failure of
equipment, or installation of that equipment. Unless with the express authority of POOLRITE any repair or
replacement shall be provided only by POOLRITE or its authorised Distributors and this warranty shall not extend to
any expenditure otherwise incurred.
Troubleshooting
If the Pump and Motor runs but there is little or no water flow, the following conditions may apply:
Check to see if the Pump is not primed. Air leaks in suction
Filter needs cleaning lines .
or is blocked.
Refer to Re-prime as per Check for air bubbles
Filter Instruction instructions in under Clear Lid and
Manual. "Starting tighten.
Pump".
If the motor does not run, the problem could be that:
Power not connected Overload tripped
Check power point by plugging in a Poolrite Motors incorporate an
portable appliance to ensure power Internal Switch that will reset
is available. Also check Fuses and automatically after the Motor
Main Power Supply Switch has cooled.
Warning
he Pump Motor is an electrical device and as such should not be disassembled or serviced by anyone other than an authorised Poolrite Service Technician or qualified Elec-
T
tricial Service Company. This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to
ensure that they can use the appliance safely.
Young children should be supervised to ensure that they do not play with the appliance.
Also, any other problems that cannot be corrected by routine maintenance should be attended to by an experienced Pool Service Technician.
Safe Use and Care
union adapter
150mm (min) pump body
Blockages Water on ground under Pump unable to draw
the Pump and Motor water from the pool
usually indicates a
damaged Pump Shaft
Seal
Check Strainer Basket This should be Check Strainer Basket
and Pool Skimmer repaired immediately and Pool Skimmer
Basket are free of or further damage Basket are free of
obstruction. may occur. obstruction. If a
blockage is suspected
inside the Pump or
in the Pipework the
advice of your pool
ician should
be sought.
Blockage preventing Pump from Motor fused or "burnt out"
rotating.
If a Pump or Pipework blockage is "Burning" smell evident -
suspected that is preventing the replacement
motor from rotating, the advice of may be required.
your pool service technician should
be sought.
clear lid
discharge port
union adapter
suction port
strainer basket
strainer port