Mackie DL806 Installation Instructions page 2

iPad Air 2 Rail Installation
If using an iPad Air, please follow steps 8-10 to the right.
If using an iPad Air 2, please thoroughly wash and dry your
hands first and continue on with the instructions below.
1. Add isopropyl alcohol to the clean, dry cloth
and use it to wipe down the iPad Air tray insert next
to the rails (between the dotted lines) as displayed
below. Let dry thoroughly.
2. Doing your best to not touch any part of the adhesive,
remove the adhesive backing paper of one of the iPad Air 2
rail strips.
3. With the adhesive side facing the tray insert, line up,
angle and place the first rail strip butted up next to the tray
insert's rail, as shown below.
4. Keeping the rail strip butted up next to the tray insert's
rail, continue to apply pressure while pushing the rail strip
down against the tray insert until the adhesive sticks.
5. Using a round, non-marking object, – the body of a pen
or pencil, for example – apply pressure to the entire length
of the rail strip for approximately 20-30 seconds.
6. Follow steps 2-5 above for the second adhesive rail strip.
7. It takes approximately 24 hours for the adhesive to fully
set. Continue on with the instructions to the right.
LOUD Technologies Inc. • 16220 Wood-Red Road NE
Woodinville • WA • 98072 • 800/258-6883
Outside the U.S. call 425/487-4333 • FAX 425/487-4337
iPad Air Tray Insert Installation
8. Slide the iPad Air / iPad Air 2 tray insert on top of
the mixer tray, making sure to line up the sides and the
screw holes.
Tray
9. Place the screws back into the DL mixer from where
they were removed. Screw them into place, but do not
overtighten. If the iPad fit is too tight, loosen all four screws,
then tighten the ones closest to the connector first.
Screw
here
iPad Air 2 Rail Strip
iPad Air 2 Rail Strip
Screw
here
10. To use the PadLock
you will need to install the two
nylon washers (included in this
kit). Align them flat against the
threads of each PadLock screw
put the driver into the screw
head and slowly turn the screw
to thread the washer over the
screw threads. Apply moderate
pressure against the washer
while turning the screw so the
washer threads. Stop when the
washers clear the screw threads.
Note: This kit contains four
nylon washers, but two are
spares. Keep the other washers
in case the couch eats up the
others, never to be seen again.
Disclaimer: LOUD Technologies Inc. continually engages in research related to product improvement.
New material, production methods, and design refinements are introduced into existing products without
notice as a routine expression of that philosophy. For this reason, any current LOUD Technologies Inc.
product may differ in some respect from its published description, but will always equal or exceed the
original design specifications unless otherwise stated.
Part No. SW1059 Rev B 06/15
© 2015 LOUD Technologies Inc. All Rights Reserved.
Tray Insert
Screw
here
Screw
here
,
™
,
™