Mackie DL806 Installation Instructions

iPad Air / iPad Air 2 Tray Kit Installation Instructions
IMPORTANT!
The contents of this kit allow you to replace the iPad tray insert currently installed on the DL806 or DL1608 mixer with
an iPad Air or iPad Air 2 tray insert. Before installing, ensure that you have the right iPad, docking connector and tray insert
for your combination. See the iPad to DL Compatibility Matrix for the latest information:
http://www.mackie.com/products/dlseries/specs
Please first read these instructions carefully to ensure you feel capable of completing the described tasks. Failure
to follow the exact instructions in this document may result in personal injury or damage to the DL806, DL1608, iPad,
or contents of the kit and may void the warranty, as well.
Web: http://www.mackie.com/support
Email: techmail@loudtechinc.com
Phone: 425-487-4333
Toll-free: 800-898-3211
Parts
iPad Air / iPad Air 2 Tray Kit Contents – Part No. 2043589:
iPad Air / iPad Air 2 Tray Insert (1) – Part No. 2042082
iPad Air 2 Rail Strips (2) – Part No. 2046055
Black Nylon Washers (4) – Part No. 2037889
This instruction sheet (1) – Part No. 2043591
Tools
Required Tools (not included):
Phillips screwdriver
Isopropyl alcohol
Clean, dry cloth
Getting Started
Before doing anything else...
• Turn off the mixer.
• Disconnect all cords.
• Remove mixer from the rack (if applicable).
• Place the mixer on a soft and dry flat surface.
iPad Tray Insert Removal
1. Remove the four screws holding the tray insert
to the mixer, numbered 1 to 4 in the illustration below.
Keep the screws in a safe place, as you will use them
again.
1
2. Remove the tray insert from the mixer and save it
somewhere safe! You might need to use it again.
Tray
2
4
3
Tray Insert