Roland Music Atelier AT20s Owner's Manual page 104

Roland owner's manual music atelier at20s
Hide thumbs Also See for Music Atelier AT20s:
Table of Contents

Advertisement

Display Messages
■ E.30
fig.E.30
Meanings:
• The Rhythm data is excessively large, and cannot be
loaded.
• The performance data is excessively large, and cannot
be loaded.
• Since the internal memory is full, recording or editing
is not possible.
■ E.40
fig.E.40
Meanings:
• The AT-20S cannot deal with the excessive MIDI data
sent from the external MIDI device. Reduce the amount
of MIDI data sent to the AT-20S.
■ E.41
fig.E.41
Meanings:
• A MIDI cable or computer cable has been disconnected.
Connect it properly and securely.
■ E.43
fig.E.43
Meanings:
• The Computer Switch is set to a wrong position or the
computer is set wrongly. Switch off the AT-20S then set
the Computer Switch to the correct position and set the
computer correctly. After that, switch on the AT-20S
again.
■ E.51
fig.E.51
Meanings:
• There is something wrong with the system. Repeat the
procedure from the beginning.
104
■ Others
fig.ot-02
Meanings:
• The AT-20S is warning you that its memory will soon
become full to capacity, so not much more recording can
be done.
fig.ot-03
Meanings:
• To carry out the procedure, you first need to erase perfor-
mance data in the AT-20S. This message asks you to
confirm that you don't mind doing this. To erase the data,
press the [Rec] button.
When you do not want to erase it, press the [Reset] button
then save the data on disk.
fig.ot-04
Meanings:
• This Registration is already being used. To overwrite the
previous Registration data in this memory, press the [Rec]
button. If you decide to keep the previous Registration
data in this memory and save your settings in an unused
memory, press the [Reset] button, press the [Select] button
to select a number for which "- - -" is displayed, and then
save the data.
fig.ot-05
Meanings:
• There already is performance data having the same name
on the disk.
To replace the existing data with the new version, press
the [Rec] button. To save it as a separate new file, press the
[Reset] button first. Then, after changing the name, save it
on disk.

Advertisement

Table of Contents
loading

Table of Contents