Advertisement
Programmed Playback
You can make a playlist of your favourite tracks/files from a disc or USB device using Programmed Playback.
,
This function is supported only on stop status.
To make Programmed Playback list
Press to enter the edit mode.
a
Select a track/file and confirm.
b
Press again to exit from the edit mode.
c
,
A playlist of up to 20 tracks/files can be entered for CD/USB1/USB2.
,
Repeat steps b to store other files.
Specification
ENGLISH
Refer to the main label on
Power Requirements
the unit.
Refer to the main label on
the unit.
Power Consumption
Networked standby : 0.4 W
(If all network ports are
activated.)
Bus Power Supply
5 V 0 500 mA
(USB)
Total Output
1000 W
Design and specifications are subject to change
without notice.
CM4750-FB_DKENHLK_SIM_1415_1416.indd 4
To enjoy Programmed Playback
Press again after you make the list.
a
Press to play the list.
b
Press twice to exit from Programmed
Playback mode.
To delete Programmed Playback List
Press in stop status.
a
Press repeatedly to select a track/file.
b
Press to delete selected song.
c
DELETE
Safety Information
Additional Information
Music File Requirement
Sampling frequency
y MP3 : 32 - 48 kHz
y WMA : 32 - 48 kHz
Bit rate
y MP3 : 32 - 320 kbps
y WMA : 40 - 192 kbps
Maximum files
Data CD : 999 / USB : 2000
Maximum folders
Data CD : 99 / USB : 200
File extensions
y ".mp3"
y ".wma"
CD-ROM file format
ISO9660+JOLIET
USB Flash Drive
Devices that support USB2.0 or USB1.1.
Bluetooth
Codec
SBC
This device is equipped with a portable battery or accumulator.
CAUTION
Safety way to remove the battery or the battery from the
RISK OF ELECTRIC SHOCK
equipment: Remove the old battery or battery pack, follow the
DO NOT OPEN
steps in reverse order than the assembly. To prevent contamination
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT
of the environment and bring on possible threat to human
and animal health, the old battery or the battery put it in the
REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
appropriate container at designated collection points. Do not
dispose of batteries or battery together with other waste. It is
recommended that you use local, free reimbursement systems
This lightning flash with arrowhead symbol
batteries and accumulators. The battery shall not be exposed to
within an equilateral triangle is intended to
excessive heat such as sunshine, fire or the like.
alert the user to the presence of uninsulated
dangerous voltage within the product's
POWER: This unit operates on a mains supply of 200 - 240 V ~,
enclosure that may be of sufficient magnitude
50 / 60 Hz.
to constitute a risk of electric shock to persons.
Wiring: This unit is supplied with a BS 1363 approved main plug.
When replacing the fuse, always use of the same rating approved
to BS 1362. Never use this plug with the fuse cover omitted. To
The exclamation point within an equilateral
triangle is intended to alert the user to
obtain a replacement fuse cover contact your dealer. If the type of
the presence of important operating and
plug supplied is not suitable for the mains sockets in your home,
maintenance (servicing) instructions in the
then the plug should be removed and a suitable type fitted. Please
literature accompanying the product.
refer to the wiring instructions below:
Warning: A mains plug removed from the mains lead of this unit
must be destroyed. A mains plug with bared wires is hazardous
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO
if inserted in a mains socket. Do not connect either wire to the
earth pin, marked with the letter E or with the earth symbol 6 or
NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
coloured green or green and yellow. If any other plug is fitted, use
CAUTION: The apparatus shall not be exposed to water (dripping
same rating of fuse in the plug.
or splashing) and no objects filled with liquids, such as vases, shall
Important: The wires in this mains lead are coloured in accordance
be placed on the apparatus.
with the following codes:
WARNING: Do not install this equipment in a confined space such
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the wires in
as a book case or similar unit.
the mains lead of this unit may not correspond with the coloured
CAUTION: Do not use high voltage products around this product.
marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
(ex. Electrical swatter) This product may malfunction due to
electrical shock.
which is marked with the letter N or coloured black. The wire which
is coloured brown must be connected to the terminal which is
CAUTION: Do not block any ventilation openings. Install in
marked with the letter L or coloured red.
accordance with the manufacturer's instructions.
Slots and openings in the cabinet are provided for ventilation and
to ensure reliable operation of the product and to protect it from
over heating. The openings shall be never be blocked by placing
the product on a bed, sofa, rug or other similar surface. This product
shall not be placed in a built-in installation such as a bookcase or
rack unless proper ventilation is provided or the manufacturer's
instruction has been adhered to.
CAUTION: This product employs a Laser System.To ensure proper
use of this product, please read this owner's manual carefully and
retain it for future reference. Shall the unit require maintenance,
contact an authorized service center.
Use of controls, adjustments or the performance of procedures
other than those specified herein may result in hazardous radiation
exposure. To prevent direct exposure to laser beam, do not try to
open the enclosure.
CAUTION concerning the Power cord
The Power Plug is the disconnecting device. In case of an
emergency, the Power Plug must remain readily accessible.
,
The USB function of this unit does not support all USB devices.
,
Using NTFS file system is not supported. (Only FAT(16/ 32) file system is supported.)
,
External HDD, Card readers, Locked devices, or hard type USB devices are not supported.
,
The DTS is not supported. In case of DTS audio format, audio is not output.
,
How to disconnect the wireless network connection or the wireless device
Turn off the unit by pressing the power button for more than 5 seconds.
2015-02-26
4:28:09
Advertisement
