General TS06 User Manual page 7

material with a moisture reading above 19.9%. To silence the
alarm, press and hold the MODE button.
If silenced, the high moisture level alarm will automatically
be re-enabled after the TS06 is powered off and powered
on again. To re-enable the alarm without powering off the
meter, press and hold the MODE button.
To hold any reading ("freeze" the display), squeeze the
trigger (Fig. 1, Callout G). This will cause the word HOLD to
appear in the upper right corner of the LCD. To resume
measuring, squeeze the trigger again to make HOLD
disappear. This feature allows you to make a measurement in
a dark place or around a corner, hold the reading, and display
it within 3 minutes later where the lighting is better.
Measurements can be held for up to 3 minutes—the duration
of the meter's Auto Power Off trigger.
To power off the meter, press the
more than 2 seconds.
To use the TS06 with your phone, begin by downloading
the ToolSmart
Store and installing it. Then, pair the meter and your phone by
activating Bluetooth on your phone and pressing the
button (Fig. 1, Callout E) on the meter.
Pressing the
blink on the LCD for 30 seconds while the meter searches for
a device to pair with. If no Bluetooth device is detected within
30 seconds, Bluetooth transmission will cease and the
meter's internal Bluetooth circuitry will power down to save
battery power.
A tutorial on the app explains how to save moisture level
measurements to your phone and overlay them on photos of
your project taken by the phone's camera.
™ app from the iTunes Store or Google Play
button on the TS06 will cause the
button and hold it for
icon to
7