Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Forest SHUTTLE S
Summary of Contents for Forest SHUTTLE S
- Page 1 FOREST SHUTTLE® S / L / M RECEIVER...
- Page 2 → DIRECTLY AFTER STOPPING OF THE MOTOR (AT OPEN POSITION) THE YELLOW LED WILL LIGHT UP. NOW YOU CAN ADJUST THE OPEN POSITION TO DESIRED POSITION. → WAIT UNTIL THE YELLOW LED GOES OFF, THE END POSITIONS ARE NOW STORED INTO MEMORY. 2 │ Installing the Forest Shuttle S / L / M Receiver...
- Page 3 Shuttle® L the Shuttle® S / M Rec and connect the AC plug to the wall socket. loop the cord through the strain relief 3 │ Installing the Forest Shuttle S / L / M Receiver...
- Page 4 ⑥ Setting the end limits of the FOREST SHUTTLE® S / L / M Receiver Before setting the end limits, the RF remote or IR remote channel can be programmed. The stack back (adjusted open limit) can be set by remote or switch. For programming see page 5.
- Page 5 For resetting only the end limits: press button 4x. To confirm, press and hold once more for 4 seconds until the led blinks 3 times and goes OFF. When a Forest remote is programmed to the Shuttle®, the end limits can also be reset by pressing 5 times the P button and 5 times the STOP button on the remote.
- Page 6 Connecting to port 1 or port 2 of the FOREST SHUTTLE® S / L / M Receiver do-it-yourself plug pin8 pin1 pin8 pin1 (CLOSE) (OPEN) (CLOSE) (OPEN) MANUAL SWITCH CONNECTED TO DRY CONTACT INPUTS A manual switch or a relay output of a Home Automation System can easily be connected to the Shuttle®.
- Page 7 Programming Master – Slave function to the FOREST SHUTTLE® M Receiver The Forest Shuttle® M Receiver can be programmed as MASTER and SLAVE motor. Two motors are needed, connected together by a cable from Port 1 to Port 1. Configuration can be done by means of pressing the configuration button on the Shuttle® motors: Situation 1 (normal Shuttle®...
- Page 8 If another power supply is used or a central power supply, each Shuttle® S must be protected with a 2.5A slow fuse. Each Shuttle® M Receiver must be protected with a 4A slow fuse. Shuttle S 225mm 77mm 49mm Shuttle M 270mm 77mm 49mm Shuttle L 305mm 77mm 49mm 8 │ Installing the Forest Shuttle S / L / M Receiver...
- Page 9 It is important for the safety of persons to follow these instructions. Save these instructions. Do not use the product for any other purpose than intended. In order for the Forest Shuttle® S / L / M Receiver to function correct and safe, the complete curtain system must be assembled with original parts and devices of Forest Group Nederland B.V.
Need help?
Do you have a question about the SHUTTLE S and is the answer not in the manual?
Questions and answers